Installation, cont’d
Twisted pair output/input
Terminating shielded cable
CAT 5/5e/6/7 twisted pair cable is not provided with the transmitter/receiver pair. You may purchase cables that have been precut to the required length and terminated to the T586A or T586B standard (see the table on the next page).
Alternatively, purchase bulk cable and use the
NThe transmitter and receiver pair works with unshielded twisted pair (UTP) or shielded twisted pair (STP) cables. To ensure FCC Class A and CE compliance, and for optimum performance, STP cables are recommended.
NDo not use Extron Skew Free Cable with this product.
1. Cut the cables to the required length. All three cables should be the same length.
2. Remove about 7/8" (2.2 cm) of the outer coat. If using STP cable, peel back the shielding and fold it over the top of the outer coat.
Peel back shield and fold back.
3. Cut away and discard the clear cellophane inner wrapper that extends beyond the folded back shielding.
4. Cut a piece of
Aluminum Tape | Wrap tape around folded foil shielding. | |
Slightly overlap. | ||
| ||
| Cut and save the excess tape | |
| for other connectors. |
5. Separate the individual wires, and arrange them so that all eight wires are side by side in the same order as the T586A or T586B standard shown at the top of the next page. Both ends of a cable must be wired to the same standard (T586A or T586B).