Installation, cont’d
Under-desk mounting
The figure below shows how to mount the DVI DL 201 Tx under a desk or podium, using the optional Extron MBU 123 under desk mounting kit (PN 70-212-01). To mount the
DVI DL 201 Rx, the optional Extron MBU 125 under desk mounting kit (PN 70-077-01, not shown) must be used. For either unit, follow these instructions:
1. Remove rubber feet if these have been installed on the bottom of the unit.
2. Secure the mounting brackets to the unit, using the four 4-40 screws provided (see the figure below).
Under-desk mounting the DVI DL 201 Tx
3. Hold the unit with the brackets attached against the underside of the table or other furniture. Mark the location of the screw holes of the bracket on the mounting surface.
4. Drill four pilot holes, each 3/32" (2 mm) in diameter by 1/4" (6.3 mm) deep in the mounting surface at the marked screw locations.
5. Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until just less than 1/4" (6.3 mm) of the screw head protrudes.
6. Guide the mounting screws through the slots in the brackets and place the unit tight against the surface.
7. Slide the unit slightly in or out so that it is held in place by the screws; tighten all four screws to secure the unit in place (see the figure above).