Extron electronic DVI DL 201 Rx, DVI DL 201 Tx user manual Connections, Tia/Eia

	TIA/EIA	TIA/EIA
Pin #	T 586 A	T 586 B	Cable 1	Cable 2	Cable 3
	Wire color	Wire color
1	White-green	White-orange	Data 0+	CEC	Data 3+
2	Green	Orange	Data 0+	HPD	Data 3+
3	White-orange	White-green	IDCK+	RS-232 Tx/IR+	N/C
4	Blue	Blue	Data 1+	DDC Clock	Data 4+
5	White-blue	White-blue	Data 1+	+12 V	Data 4+
6	Orange	Green	IDCK-	RS-232 Rx	N/C
7	White-brown	White-brown	Data 2+	DDC Data	Data 5+
8	Brown	Brown	Data 2+	Ground	Data 5+

6. Feed the wires into the RJ-45 connector (see the figure at right) and crimp the cable in the normal manner (see the figure below), folding the tangs of the connector over the shielded tape.

Side Pins:

1 2 3 4 5 6 78

Insert

Twisted

Pair Wires

Crimped Connector

Connections

Use RJ-45 connectors to link the output from the transmitter to the appropriate input on the receiver. Three CAT 5/5e/6/7 twisted pair (TP) cables connect the transmitter with the receiver.

NThe transmitter and receiver pair works with unshielded twisted pair (UTP) or shielded twisted pair (STP) cables. To ensure FCC Class A and CE compliance, and for optimum performance, STP cables are recommended.

Connect the output from the transmitter to the input of the receiver that has the same number:

•Transmitter port 1 connects to receiver port 1.

•Transmitter port 2 connects to receiver port 2.

•Transmitter port 3 connects to receiver port 3.

DVI DL 201 Tx/Rx • Installation 2-15