Contents
DVI DL 201 Tx/Rx
Dual Link DVI Transmitter and Receiver
Precautions
Safety Instructions English
安全须知 中文
FCC Class a Notice
Page
Connect the display to the local monitor output
Power on the source device
Quick Start Guide - DVI DL 201 Tx/Rx
Amber while the Edid information is read
Quick Start Guide - DVI DL 201 Tx/Rx, cont’d
To use DDC pass-through routed to the local monitor
Table of Contents
Table of Contents, cont’d
One
DVI DL 201 Tx/Rx
About this Manual
DVI DL 201 Tx/Rx Features
Introduction
About the DVI DL 201 Tx/Rx
Typical Application for the DVI DL 201 Tx/Rx
Extron DVI DL 201 Tx
Introduction, cont’d
Two
Mounting the DVI DL 201 Tx/Rx
Installation
Tabletop placement
Rack mounting
Rack mounting procedures
Installing the DVI DL 201 Tx on a rack shelf
Installation, cont’d
Under-desk mounting
Under-desk mounting the DVI DL 201 Tx
Through-desk mounting
Through-desk mounting the DVI DL 201 Rx
Pole mounting
Projector mounting the DVI DL 201 Rx
DVI DL 201 Tx/Rx Installation
Installation, cont’d Panel Features
DVI DL 201 Tx front panel features
DVI DL 201 Tx front panel features
DVI DL 201 Tx rear panel features
DVI DL 201 Tx
DVI DL 201 Rx front panel features
DVI DL 201 Rx front panel features
DVI DL 201 Rx rear panel features
DVI DL 201 Rx rear panel features
Installation, cont’d Cable Connections and Switches
DVI-D input
DVI-D output
Pin Signal
Twisted pair output/input
Terminating shielded cable
Connections
TIA/EIA
Single Link/Dual Link DVI
Video Resolution
Single Link Mode Dual Link Mode
60 Hz
DDC switches
Off position
Control pass-through
Signal S, from the control device to
RS-232 signals
IR signals
Tx to Tx Rx to Rx Ground to
Power input
Connecting power to DVI DL 201 Tx/Rx
Three
Configuration and Operation
Configuration
Using the Edid Minder to read and store Edid from a display
Connect the source device to the transmitter Input
Using the Edid Minder with the default Edid
Set the Edid Minder switch to the on up
Connect the display device to the receiver
Configuration and Operation, cont’d
Using pass-through mode with DDC routed to a local monitor
Power on the display device
Power on the local monitor, if required
Configuration and Operation, cont’d Setup
Troubleshooting
DVI DL 201 Tx/Rx Configuration and Operation
Configuration and Operation, cont’d
AAppendix a
Video
Specifications
Reference Information
Video input and loop-through transmitter
Video output receiver
Control/remote external device pass-through
General
Warranty Years parts and labor
Enclosure dimensions
Depth excludes connectors
#60 ‑604 ‑20
Accessory Part number
Optional Accessories
Included parts Replacement Part number
Included Parts
Reference Information
Extron’s Warranty
USA, Canada, South America Japan Central America
Extron Electronics. All rights reserved