GE 960 Series manual Level II Programming Parameters, Parameter Name

Table 3 - Level II Programming Parameters

Parameter
Name	Description	Range of Values	Minimum	Default	Units of	Notes
			Increments		Measure
P6	Refill controller	1 to 99	1	33		Enter the value molded into the
						end of the refill controller.
P7	Regenerant	1 to 99	1	25		Select number from Table 4 and
	draw value					enter that number.
P8	Not used	NA	NA	NA	NA	NA
P9	Backwash time	3 to 30	1	14	Minutes	Skip this parameter to accept the
						default or enter a value.
P10	Slow rinse time	8 to 125	1	40	Minutes	Skip this parameter to accept the
						default or enter a value.
P11	Fast rinse time	2 to 19	1	4	Minutes	Skip this parameter to accept the
						default or enter a value.
						0 = U.S., 1 = metric. Skip this
P12	Units of Measure	0 to 1	1	0		parameter to accept U.S. or enter
						1 for metric.
						0 = 12-hour clock.
P13	Clock mode	0 to 1	1	0		1 = 24-hour clock. Skip this
						parameter for a 12-hour clock or
						enter 1 for a 24-hour clock.
	Calendar					0 = no calendar override. Skip this
P14		0 to 30	1	0	Days	parameter for no calendar
	override
						override or enter a value.
						0 = variable reserve, 1 = fixed
						reserve, 2 = variable reserve with
						immediate regen,
P15	Reserve type	0 to 3	1	0		3 = fixed reserve with immediate
						regen. Skip this parameter to
						accept the default or enter a
						different reserve type.
	Fixed reserve					Description depends on the value
					Percent of	entered for P15. Skip this
P16	capacity or initial	0 to 70	1	30
					capacity	parameter to accept the default or
	average value
						enter a different value.
P17	Operation type	0 to 2	1	2		2 = 5-cycle
						cocurrent conditioner.
						0 = none, 1 = salt/capacity change
P18	Salt/capacity	0 to 1	1	0		locked out. Skip this parameter to
	change lockout					accept the default or enter 1 to
						lock out salt/capacity change.
						Loads in a set of default values.
P19	Factory defaults		1	99		Refer to the Special Notes for
						Level II Parameters section in this
						manual. Do Not Change.

9