Gas connection, Instructions for the Installer | Smeg PTS723-3

Image 6

Smeg PTS723-3 manual Gas connection, Instructions for the Installer

Contents

7. Using the hob Table of Contents1. Precautions for safety and use 2. Fitting the appliance in the top 8. Cleaning and maintenance NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD Precautions for Safety and Use1. Precautions for safety and use NEVER ATTEMPT TO REPAIR THE APPLIANCE YOURSELF Instructions for the Installer 2. Fitting the appliance in the top2.1 Fixing to the supporting structure Fit the insulating gasket provided carefully around the outside edge of the hole made in the top as shown below, pressing it down with your hands so that its entire surface fits snugly. Follow the dimensions shown, depending on the model of hob to be installed, bearing in mind that on both models the long front edge must be flush with the hole. Fix the hob to the structure using the brackets A provided. Carefully trim off the excess edge of the gasket B. The dimensions in the drawing below refer to the hole on the inside edge of the gasket 3. Electrical connection 4. Gas connection 4.1 Bottled gas connection 4.2 Room ventilation4.3 Combustion gas discharge 5. Adapting to different types of gas 5.1 Removing the hob skin 5.4 Adjusting for natural gas 5.2 Adjusting for bottled gas5.3 Adjusting for town gas Nominal BurnerheatBottled gas - G30/G31 30/37 mbar capacity kW 5.8 Adjusting the minimum for bottled gas 5.5 Adjusting the primary air flow5.7 Adjusting the minimum setting for natural gas and town gas 5.6 Reassembling the hob skin 5.9 Hob burner layout 5.10 Greasing the gas tapsBurner type Instructions for the User 6. Description of controls6.1 The front panel 7.3 Practical hints for using the burners 7. Using the hob7.1 Lighting burners with safety device 7.2 Positioning the griddle plate 8. Cleaning and maintenance 8.1 Cleaning stainless steel8.2 Cleaning the components Page 914773119/ B