Extron electronic DP DA2 manual Front Panel Features, Power LED, Config USB Port

Page 15

Front Panel Features

Power LED

The Power LED lights green when the unit is receiving power.

Config USB Port

Connecting to the USB Port

The mini type B USB port is located on the DP DA2 front panel. It can be used to connect the distribution amplifier to a host computer for updating firmware or for configuration using SIS commands. Alternatively, use the RS-232 captive screw connector (see page 8). For complete information about SIS commands, see the “SIS Commands” section on page 13.

1.Connect a USB A to mini B cable between the USB Config port on the front panel of the DP DA2 and the USB port of the PC.

Mini Type B	Type A
USB	USB

USB

Ports

USB Cable

	INPUT OUTPUTS
	SIGNAL
	1	2
CONFIG	HDCP
	HDCP

DP DA2

DISPLAYPORT DISTRIBUTION AMPLIFIER

DP DA2 Front Panel	Computer

Figure 5. Connecting a PC to the DP DA2 Front Panel USB Port

DP DA2 • Panel Features

Image 15

Contents Distribution Ampliﬁer DP DA2User Guide DisplayPortSicherheitsanweisungen Deutsch Safety InstructionsSafety Instructions English Instructions de sécurité FrançaisTrademarks Specifications AvailabilityFCC Class A Notice CopyrightSoftware Commands Conventions Used in this GuideNotifications Safety Instructions ContentsDP DA2 Contents About the DP DA2 DP DA2 Features DP DA2 FeaturesIntroduction About the DP DA2Application Diagram TouchLinkTCP/IP Panel Features Rear PanelFront Panel Power Supply Rear Panel FeaturesFunction Display Port ConnectorsRecording EDID Dual Mode DisplayPortEDID Minder EDID Store push button and LEDSummary DIP switchesDP DA2 Pin RS-232ControlMute Control Host PC PinConnecting to the USB Port Front Panel FeaturesPower LED Config USB PortDP DA2 Panel Features Figure 7. Installing the Software AutomaticallySignal and HDCP LEDs Signal LEDsHDCP LEDs Setup •Error Messages SIS CommandsIntroduction to SIS Introduction to SIS Symbols Used in this GuideSymbols Used in this Guide Error MessagesTable 1. ASCII to HEX Conversion Table Command and Response Table for SIS Commands Downloading DP DA2 Firmware Downloading and Installing Firmware LoaderUpdating Firmware Downloading and Installing Firmware LoaderFigure 9. Firmware Link on the Download Tab Downloading DP DA2 FirmwareFigure 10. Opening Firmware Loader Loading the Firmware to the DP DA2DP DA2 Updating Firmware DP DA2 Updating Firmware DP DA2 Updating Firmware Resetting Firmware to the Factory Default VersionDP DA2 Setup Guide Reference InformationIncluded Parts Optional PartsRack Mounting Desktop PlacementRack Mounting Procedure MountingExtron Warranty