DIP switches, Summary | Extron electronic DP DA2 specs

DIP switches

Two DIP switches are used to select which of two EDID values is presented to the source device (DIP switch 1) and whether the output is in normal or extend mode (DIP switch 2).

DIP switch 1 — In the Default (up) position, the EDID value is the factory-stored default, with a native resolution of 1080p and 2-channel audio. In the Stored (down) position, the most recently recorded EDID value is used (this file overwrites previously stored values). Before any other EDID file is recorded, the factory default EDID is also stored here.

To record EDID, follow the instructions in the “Recording EDID” section on the previous page.

DIP switch 2 — In the Normal (down) position, the DP DA2 provides two duplicate outputs of up to 2560x1600 @ 60Hz and multi-channel audio. If the DIP switch is in the Extend (up) position, the DP DA2 provides an image with a resolution of up to 3840x1080 @ 60 Hz and 2-channel audio extended over two output displays.

Available Extend Mode Resolutions	Resolution per Output

3840x1080 @ 60 Hz	1920x1080 @ 60 Hz

3360x1050 @ 60 Hz	1680x1050 @ 60 Hz

2880x900 @ 60 Hz	1440x900 @ 60 Hz

2560x1024 @ 60 Hz	1280x1024 @ 60 Hz

Summary

DIP Switch 1	DIP Switch 2	Function

Stored (down)	Normal (down)	Stored EDID is used and normal mode

Default (up)	Normal (down)	Default EDID is used and normal mode

	Extend (up)	Extended mode

NOTE: If DIP switch 2 is set to Extend, DIP switch 1 is non-functional

DP DA2 • Panel Features