Extron electronic DP DA2 manual Panel Features, Rear Panel, Front Panel

Panel Features

This section describes the panel features and connections of the DP DA2.

Rear Panel

DP DA2

		INPUT		OUTPUTS		EDID		REMOTE
	POWER		1	2		DEFAULT
							EXTEND
12V						EDID		RS-232	MUTE
0.6A MAX						STORE
							NORMAL	Tx Rx G	1 2
						STORED
	a	b		c	d	e f		gh

Figure 2. DP DA2 Rear Panel

APower — Connect the provided power supply to this 2-pole, 3.5 mm captive screw connector.

BInput — Connect the source device to this female DisplayPort connector.

COutputs — Connect up to two display devices to these female DisplayPort connectors.

DEDID Minder LED — Lights red, amber, or green, showing current EDID Minder state.

EEDID Minder Store push button — This recessed button activates EDID store.

FEDID Minder DIP switches — Used to configure the EDID Minder features.

GRS-232 control — Connect the transmit (Tx), receive (Rx), and ground (G) connectors of this 5-pole, 3.5 mm captive screw connector to a control PC.

HMute control — Connect the ground (G) and either pin 1 (to mute output 1) or pin 2 (to mute channel 2).

Front Panel

		INPUT	OUTPUTS
		SIGNAL
			1	2
	CONFIG	HDCP
			DP DA2
		DISPLAYPORT DISTRIBUTION AMPLIFIER
i	j		k

Figure 3. DP DA2 Front Panel

IPower LED — Lights green when the unit is receiving power.

JConfig USB port — Connect this USB port to a control PC.

KSignal and HDCP LEDs — Provide information about the signal and HDCP encryption status of the input and outputs.

DP DA2 • Panel Features 3