Extron electronic DP DA2 FCC Class A Notice, Specifications Availability, Copyright, Trademarks

Page 3
FCC Class A Notice

FCC Class A Notice

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference.

2.This device must accept any interference received, including interference that may cause undesired operation.

The Class A limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the user guide, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense.

NOTE: This unit was tested with shielded cables on the peripheral devices. Shielded cables must be used with the unit to ensure compliance with FCC emissions limits.

For more information on safety guidelines, regulatory compliances, EMI/EMF compliance, accessibility, and related topics, click here.

Specifications Availability

Product specifications are available on the Extron website, www.extron.com.

Copyright

© 2012 Extron Electronics. All rights reserved.

Trademarks

All trademarks mentioned in this guide are the properties of their respective owners

Image 3
Contents Distribution Amplifier DP DA2User Guide DisplayPortSicherheitsanweisungen Deutsch Safety InstructionsSafety Instructions English Instructions de sécurité FrançaisTrademarks Specifications AvailabilityFCC Class A Notice CopyrightSoftware Commands Conventions Used in this GuideNotifications Safety Instructions ContentsDP DA2 Contents About the DP DA2 DP DA2 Features DP DA2 FeaturesIntroduction About the DP DA2Application Diagram TouchLinkTCP/IP Panel Features Rear PanelFront Panel Power Supply Rear Panel FeaturesFunction Display Port ConnectorsRecording EDID Dual Mode DisplayPortEDID Minder EDID Store push button and LEDSummary DIP switchesDP DA2 Pin RS-232ControlMute Control Host PC PinConnecting to the USB Port Front Panel FeaturesPower LED Config USB PortDP DA2 Panel Features Figure 7. Installing the Software AutomaticallySignal and HDCP LEDs Signal LEDsHDCP LEDs Setup •Error Messages SIS CommandsIntroduction to SIS Introduction to SIS Symbols Used in this GuideSymbols Used in this Guide Error MessagesTable 1. ASCII to HEX Conversion Table Command and Response Table for SIS Commands Downloading DP DA2 Firmware Downloading and Installing Firmware LoaderUpdating Firmware Downloading and Installing Firmware LoaderFigure 9. Firmware Link on the Download Tab Downloading DP DA2 FirmwareFigure 10. Opening Firmware Loader Loading the Firmware to the DP DA2DP DA2 Updating Firmware DP DA2 Updating Firmware DP DA2 Updating Firmware Resetting Firmware to the Factory Default VersionDP DA2 Setup Guide Reference InformationIncluded Parts Optional PartsRack Mounting Desktop PlacementRack Mounting Procedure MountingExtron Warranty