| 1. Remove electrical power to unit. |
|
| To avoid electrical shock or property damage, move |
|
| the power switch to OFF and disconnect main circuit |
|
| breaker, or unplug cord at wall receptacle. |
| 2. | Using Phillips head screwdriver, remove the side panel |
Step 2 |
| closest to the controls. |
| 3. | Remove electrical wires from wire nuts. |
| 4. | Remove discs and rod from inside of unit. (See Cleaning |
|
| Section in Operator’s Manual.) |
Step 3 | 5. | Unscrew knob and lift |
|
| out of unit. |
| 6. | Loosen thumb screw and pull out on fan blade and |
|
| remove from shaft. |
| 7. | Using a 7/16" nut driver, remove the nuts securing |
|
| the blower to the unit, and remove blower from unit. |
Step 5 | 8. | Replace with new blower in reverse order. |
When placing fan blade back onto shaft, rotate fan blade on the blower shaft, while holding the blower wheel inside the control area. The fan blade should snap onto a pin at the base of the shaft.
Step 6
Step 7
203 |