Henny Penny HMI-105, HMI-103 manual To avoid burns, allow the unit to cool before cleaning

Page 10

Model HMI-103/105

3-4. SHUT DOWN AND CLEAN UP 1. Remove all power from unit by unplugging the cord or turning off the wall circuit breaker.

To avoid burns, allow the unit to cool before cleaning.

2.Remove well cover, and clean with soap and water at sink.

3.Clean all surfaces with a soft cloth, soap, and water.

Do not use steel wool, other abrasive cleaners or cleaners/sanitizers containing chlorine, bromine, iodine or ammonia chemicals, as these will deteriorate the stainless steel, and glass material, and shorten the life of the unit.

Do not use a water jet (pressure sprayer) to clean the unit, or component failure could result.

4.Clean around electrical controls and components with a damp cloth.

5.Clean glass with a non-streaking liquid glass cleaner and a soft cloth.

3-2

203

Page 9 Page 11
Image 10
Page 9 Page 11
Contents OPERATOR’S Manual Page Limited Warranty for Henny Penny Equipment Table of Contents Island Warmers FeaturesIntroduction Proper CareSafety Introduction InstallationUnpacking Electricaldatatable Operation START-UPTo avoid burns, allow the unit to cool before cleaning Operating Controls FIG. no Item no Description FunctionOperating Controls Operating Controls Page Troubleshooting Troubleshooting Guide Problem Cause CorrectionPage O S S a R Y LED203
Top Page Image Contents