Henny Penny HMI-103, HMI-105 manual O S S a R Y, Led

Page 17

air temperature probe

concentration ring assembly

clean water pan setpoint

control panel

deliming agent drain valve

float switch food probe

food probe receptacle

humidity sensor

humidity setting

LED

minimum holding temperature

module

out of water trip point

parameters

power switch

pressure sprayer

203

Model HMI-103/105

G L O S S A R Y

HENNYPENNYHOLDINGCABINETS

a round device located inside the cabinet that measures the inside air temperature and sends that information to the control panel

a metal assembly located in the water pan in the bottom of the unit that helps keep an even humidity level inside the cabinet

a preset temperature at which a sensor warns the operator that the water pan has excessive lime deposits

the components that control the operating systems of the unit; the panel is located on the top front surface of the cabinet

a cleaner used to remove lime deposits in the water pan

a device that lets the water drain from the water pan into a shallow pan on the floor; the valve should be closed while the unit is in use if humidity is desired

a device that senses low water levels in the water pan

a sensor located outside the cabinet that, when inserted into the product, communicates the temperature of the product to the control panel

the connection where the food probe is inserted in order to communicate with the control panel

a device that measures the percentage of humidity inside the cabinet during use

a preset moisture level at which the cabinet operates; this setting is programmed at the factory but can be changed in the field

an electronic light on the control panel

the lowest temperature at which a food product can be safely held for human consumption

the removable top part of the cabinet that contains all of the operating system

a preset temperature at which a sensor warns the operator that the water pan needs refilled

a preset group of setpoints designed for holding specific food products at certain temperature and humidity levels

the ON/OFF switch that sends electricity to the unit’s operating systems; this switch does not disconnect the electrical power from the wall to the unit

a device that shoots a stream of water under pressure; this device should NOT be used to clean a holding cabinet

G-1

Image 17
Contents OPERATOR’S Manual Page Limited Warranty for Henny Penny Equipment Table of Contents Introduction FeaturesIsland Warmers Proper CareSafety Unpacking InstallationIntroduction Electricaldatatable START-UP OperationTo avoid burns, allow the unit to cool before cleaning FIG. no Item no Description Function Operating ControlsOperating Controls Operating Controls Page Troubleshooting Guide Problem Cause Correction TroubleshootingPage LED O S S a R Y203