Hoshizaki L1F015102 instruction manual Electrical Connection, Set Up

Page 11

D. Electrical Connection

WARNING

THIS APPLIANCE MUST BE GROUNDED.

This icemaker requires a ground that meets the national and local electrical code requirements. To prevent possible severe electrical shock injury to individuals or extensive damage to equipment, install a proper ground wire to this icemaker. Remove the plug from the electrical outlet before any maintenance, repairs or cleaning is undertaken.

CAUTION

The GREEN ground wire in the factory-installed power cord is connected to a screw on the bracket where the cord enters the machine. If it becomes necessary to remove or replace the power cord, be sure to connect the power cord’s ground wire to this screw upon reattachment.

*This icemaker must be plugged into an independent power receptacle which has enough capacity. The maximum allowable voltage variation should not exceed ± 10 percent of the nameplate rating. See the Nameplate.

*Usually an electrical permit and services of a licensed electrician are required.

E. Set Up

IMPORTANT

Do not place heavy objects exceeding 33 lbs (15 kg) on the Top Panel.

1)Unpack the icemaker, and remove all shipping cartons, tapes and packing BEFORE operating the unit.

2)Position the icemaker in a selected site. Clean the interior with soap and water and rinse thoroughly.

3)Level the icemaker in both the left-to-right and the front-to-rear directions (when installed with or without legs). See Fig. 2.

4)When installing the unit without legs, the perimeter where the machine touches the counter should be sealed with silicone to prevent water from leaking under the icemaker.

5)When installing the unit with legs on the bottom, use the four accessory legs adjustable

8

Image 11
Contents KM-201BAH KM-260BAH KM-201BWH KM-260BWH Hoshizaki AMERICA, INC Contents KM-260BWH Specifications Nameplate RatingKM-201BAH Dimensions/ConnectionsKM-260BAH KM-201BWH KM-260BWH How to Remove Panels See Fig Location Electrical Connection Set UpWater Supply and Drain Connections See Figs KM-201BAH KM-201BWH KM-260BWH Final Checklist Startup Cleaning Procedure III. Cleaning and Maintenance InstructionsCleaning Thumbscrew Bracket L Evaporator Cube Guide Water Tank Sanitizing Procedure Following Cleaning Procedure Storage Bin and Scoop MaintenanceExterior Panels Remove the water from the potable water supply line Preparing the Icemaker for Long StorageAir Filter CondenserDrain the potable Water Tank