Hoshizaki L1F015102 instruction manual Startup

Page 16

H. Startup

CAUTION

1.All parts are factory-adjusted. Improper adjustments may result in failure.

2.If the unit is turned off, wait for at least 3 minutes before restarting the icemaker to prevent damage to the Compressor.

3.To prevent damage to the Water Pump, do not leave the Control Switch in the “SERVICE” position for extended periods of time when the Water Tank is empty.

1)Open the Water Supply Line Shut-off Valve.

2)Remove the Louver.

3)Move the Control Switch on the Control Box to the “ICE” position.

4)Turn on the power supply and allow the icemaker to operate for 5 minutes to fill up the

Water Tank.

Control Box

5)Move the Control Switch to the “SERVICE” position. Move the Service Switch to the “WASH” position.

6)Allow the icemaker to run for 5 minutes.

7)Move the Service Switch to the “DRAIN” position.

8)Allow the icemaker to drain for 2 minutes.

9)Turn off the power supply.

10)Move the Control Switch to the “ICE” position.

11)Replace the Louver in its correct position.

12)Clean the Storage Bin using a neutral cleaner. Rinse thoroughly after cleaning.

13)Turn on the power supply to start the automatic icemaking process.

ICE

Control Switch

OFF

 

SERVICE

Service Switch

WASH

 

CIRCULATE

 

DRAIN

 

Fig. 6

13

Image 16
Contents KM-201BAH KM-260BAH KM-201BWH KM-260BWH Hoshizaki AMERICA, INC Contents Specifications Nameplate Rating KM-260BWHDimensions/Connections KM-201BAHKM-260BAH KM-201BWH KM-260BWH How to Remove Panels See Fig Location Set Up Electrical ConnectionWater Supply and Drain Connections See Figs KM-201BAH KM-201BWH KM-260BWH Final Checklist Startup Cleaning III. Cleaning and Maintenance InstructionsCleaning Procedure Thumbscrew Bracket L Evaporator Cube Guide Water Tank Sanitizing Procedure Following Cleaning Procedure Exterior Panels MaintenanceStorage Bin and Scoop Preparing the Icemaker for Long Storage Air FilterCondenser Remove the water from the potable water supply lineDrain the potable Water Tank