Manitowoc Ice S1400M Section Maintenance Interior Cleaning and Sanitizing, Cleaning Procedure

Page 25

Section 4

Maintenance

 

 

Interior Cleaning and Sanitizing

GENERAL

Clean and sanitize the ice machine every six months for efficient operation. If the ice machine requires more frequent cleaning and sanitizing, consult a qualified service company to test the water quality and recommend appropriate water treatment. An extremely dirty ice machine must be taken apart for cleaning and sanitizing.

!Caution

Use only Manitowoc approved Ice Machine Cleaner (part number 94-0546-3) and Sanitizer (part number 94-0565-3). It is a violation of Federal law to use these solutions in a manner inconsistent with their labeling. Read and understand all labels printed on bottles before use.

CLEANING PROCEDURE

!Caution

Do not mix Cleaner and Sanitizer solutions together. It is a violation of Federal law to use these solutions in a manner inconsistent with their labeling.

!Warning

Wear rubber gloves and safety goggles (and/or face shield) when handling ice machine Cleaner or Sanitizer.

Ice machine cleaner is used to remove lime scale or other mineral deposits. It is not used to remove algae or slime. Refer to the section on Sanitizing for removal of algae and slime.

Step 1 Remove top cover. This will allow easiest access for pouring cleaner.

Step 2 Set the toggle switch to the OFF position after ice falls from the evaporator at the end of a Harvest cycle. Or, set the switch to the OFF position and allow the ice to melt off the evaporator.

!Caution

Never use anything to force ice from the evaporator. Damage may result.

Step 3 Remove all ice from the bin.

Step 4 To start cleaning, place the toggle switch in the CLEAN position. The water will flow through the water dump valve and down the drain. The Clean light will turn on to indicate the ice machine is in the Cleaning mode.

Step 5 Wait about two minutes or until water starts to flow over the evaporator.

Step 6 Add the proper amount of Manitowoc Ice Machine Cleaner to the water trough by pouring between the water curtain and evaporator.

Model

Amount of Cleaner

S1400M

9 ounces (266 ml)

Step 7 The ice machine will automatically time out a ten minute cleaning cycle, followed by six rinse cycles, and stop. The Clean light will turn off to indicate the Cleaning cycle is completed. This entire cycle lasts approximately 30 minutes.

Step 8 When the cleaning process stops, move the toggle switch to OFF position. Refer to “Sanitizing Procedure” on the next page.

Step 9

A.The ice machine may be set to start and finish a self-cleaning procedure then automatically start ice making again.

B.You must wait about one minute into the cleaning cycle (until water starts to flow over the evaporator) then move the switch from CLEAN to ICE position.

C.When the self-cleaning cycle is completed, an ice making sequence will start automatically.

Important

After the toggle switch is moved to the ICE position, opening the curtain switch will interrupt the cleaning sequence. The sequence will resume from the point of interruption when the curtain switch closes.

Part Number 80-1631-3

4-3

Page 24 Page 26
Image 25
Page 24 Page 26
Contents S1400M Model Ice Machines Installation Use and Care Manual Personal Injury Potential Read These Before ProceedingTable of Contents Section Maintenance Table of ContentsSection Before Calling For Service Section Ice Machine OperationSection General Information How to Read a Model NumberModel Numbers Ice Cube SizesGeneral Information Section Accessories Model/Serial Number Location Section General Information Model/Serial Number LocationWarranty Coverage Ice Machine Dimensions Section Installation InstructionsGeneral S1400M WATER-COOLED ICE MachinesIce Machine Heat of Rejection Installation Instructions Section Location of Ice MachineVoltage Section Installation Instructions Electrical ServiceMinimum Circuit Ampacity Electrical RequirementsSelf Contained ICE Machine 115/1/60 or 208-230/1/60 For United Kingdom OnlySelf Contained ICE Machine 208-230/3/60 Self Contained ICE Machine 230/1/50Water Supply Cooling Tower ApplicationsWater Inlet Lines Drain ConnectionsTypical Water Supply Drain Installation Installation Instructions SectionWater Supply and Drain Line SIZING/CONNECTIONS Section Installation Instructions Installation Check List Potential Personal Injury Situation AuCS Automatic Cleaning SystemComponent Identification Section Ice Machine OperationInitial START-UP or START-UP After Automatic SHUT-OFF Ice Machine Operation Section Sequence Of OperationHarvest Sequence 5. Water Purge Safety TimersHarvest Automatic SHUT-OFF 7. Automatic Shut-OffWater Level Ice Machine Operation Section Operational ChecksICE Thickness Check Ice Thickness CheckHarvest Sequence Water Purge Water Purge AdjustmentIce Machine Operation Section Exterior Cleaning Section MaintenanceIce Machine Inspection Water-Cooled Condenser Water Regulating ValveInstallation Maintenance Section GuardianSachet Replacement Frequency Sachet Replacement ProcedureCleaning Procedure Section Maintenance Interior Cleaning and SanitizingStep Sanitizing Procedure Maintenance SectionRemoval of Parts for CLEANING/SANITIZING Water Curtain Removal Ice Thickness Probe Water CurtainIce Thickness Probe Removal Water Trough Water Distribution TubeWater Distribution Tube Removal Water Pump Water Level ProbeWater Pump Removal Water Dump Valve Dump Valve DisassemblyDrain Line Check Valve Evaporator Tray RemovalWater Inlet Valve Pry Open the Water Regulating Valve AUCS→ Accessory Maintenance Section Removal from Service/WinterizationSELF-CONTAINED WATER-COOLED ICE Machines Checklist Section Before Calling For ServiceSafety Limit Feature Before Calling For Service SectionPage Manitowoc ICE, INC

S1400M specifications

The Manitowoc Ice S1400M is a cutting-edge ice machine designed for high volume ice production, widely popular in the restaurant and hospitality industries. This model is part of Manitowoc’s acclaimed line of ice machines, known for their durability, efficiency, and innovative features that simplify ice making while enhancing operational performance.

One of the most notable features of the S1400M is its impressive production capacity. This unit is capable of producing up to 1,400 pounds of ice per day, making it a reliable choice for businesses with high ice demands. Whether it's for cocktails, beverages, or food preservation, the S1400M ensures that there is always enough ice available to meet customer needs.

The S1400M employs Manitowoc's advanced ice-making technology, which includes a state-of-the-art 100% stainless steel evaporator. This not only enhances the longevity of the unit but also helps produce cleaner and clearer ice. The unit utilizes a patented built-in actuator that completely purges the evaporator during the harvest cycle, ensuring that the ice is free from contaminants and undesirable residues.

Furthermore, the Manitowoc S1400M is designed with energy efficiency in mind. It operates with the Energy Star certification, which means it meets strict energy efficiency guidelines set by the U.S. Environmental Protection Agency. This reduces operational costs and environmental impact, making the S1400M an excellent investment for eco-conscious businesses.

This model is also equipped with an intuitive ice thickness control system, allowing for customization of ice size according to specific needs. Users can easily set the machine to produce either half-cube or full-cube ice, catering to varying beverage requirements. Additionally, the S1400M features a user-friendly interface and digital display, providing operators with real-time machine status updates and alerts for maintenance or service needs.

Another important aspect of the S1400M is its flexible installation options. This unit can be paired with a variety of bins and dispensers, allowing businesses to optimize their space while ensuring the functionality of their ice supply. Its compact design is ideal for establishments with limited space, making it a versatile choice for bars, restaurants, and hotels.

In summary, the Manitowoc Ice S1400M represents the perfect blend of power, efficiency, and technological advancement. With its high production capacity, durable construction, customizable ice production, and energy-saving features, the S1400M stands out as a leading choice for any business requiring consistent and high-quality ice.
Top Page Image Contents