Manitowoc Ice S1800M Maintenance Section Guardian, Installation, Sachet Replacement Frequency

Page 24

Maintenance

Section 4

 

 

Guardian™

Slime is a leading cause of ice machine breakdowns and biological growth is a health concern. The Guardian™ system releases chlorine dioxide on a controlled basis to inhibit the growth of bacteria and fungi that form slime and cause malodors in the food zone of ice machines. The Guardian™ will not control mineral or other water borne buildup. Your water quality will determine the length of time before mineral buildup affects ice machine performance. Mineral buildup must be removed as often as necessary to ensure trouble-free operation of the ice machine.

INSTALLATION

If the Guardian system has been ordered, install the sachet holder in the inside of the front panel.

1. Remove front panel screws and lift panel off.

Remove

Screws

Screw Location

2.Inside the front panel there are two thumbscrew holes covered by stickers, pierce the sticker with a screwdriver.

3.Attach the sachet holder to the front panel by inserting the thumbsrews through the holes in the sachet holder and tightening the thumbscrews

4.Remove the new sachet packet from foil package and install into holder. Removing the foil package allows moisture in the air to activate the sachet contents.

5.Close the left front door and tighten the screw.

Inside Left

Front Door

SACHET REPLACEMENT FREQUENCY

Sachet packet(s) require replacement every thirty (30) days or whenever they come in direct contact with water. Refer to chart below for requirements.

Ice Machine

Sachet Use

S1800M

1 or 2*

*Although one sachet is recommended, extreme conditions may necessitate using two sachet packets.

Guardian™ sachet packets are available through your local Manitowoc ice machine dealer.

SACHET REPLACEMENT PROCEDURE

1.Loosen the left screw and open the left front door. The right front panel does not need to be removed.

2.Remove and discard spent Guardian sachet packets.

3.Remove the new sachet packet from foil package and install into holder. Removing the foil package allows moisture in the air to activate the sachet contents.

4.Close the left front door and tighten the screw.

5.Discard the use sachet packet in the trash.

CLEAN UP PROCEDURE FOR DAMAGED PACKET

1.Remove all ice from bin/dispenser and discard.

2.Initiate a cleaning and sanitizing sequence on the ice machine (see next pages).

3.Clean the bin/dispenser. Flush the drain thoroughly to prevent future drain blockage.

4.Sanitize the bin/dispenser.

5.Install a replacement sachet packet and reinstall all panels.

Guardian

Guardian™ Location

4-2

Part Number 80-1633-3

Image 24
Contents S1800M Model Ice Machines Installation Use and Care Manual Read These Before Proceeding Personal Injury PotentialTable of Contents Table of Contents Section Ice Machine Operation Section MaintenanceSection Before Calling For Service How to Read a Model Number Section General InformationModel Numbers Ice Cube SizesGeneral Information Section Accessories Section General Information Model/Serial Number Location Model/Serial Number LocationWarranty Coverage Section Installation Instructions Ice Machine DimensionsGeneral S1800 WATER-COOLED ICE MachinesInstallation Instructions Section Location of Ice Machine Ice Machine Heat of RejectionSection Installation Instructions Electrical Service VoltageMinimum Circuit Ampacity Electrical RequirementsFor United Kingdom Only Self Contained ICE Machine 115/1/60 or 208-230/1/60Self Contained ICE Machine 208-230/3/60 Self Contained ICE Machine 230/1/50Cooling Tower Applications Water SupplyWater Inlet Lines Drain ConnectionsInstallation Instructions Section Typical Water Supply Drain InstallationWater Supply and Drain Line SIZING/CONNECTIONS Section Installation Instructions Installation Check List AuCS Automatic Cleaning System Potential Personal Injury SituationSection Ice Machine Operation Section Ice Machine OperationComponent Identification Ice Machine Operation Section Sequence Of Operation Initial START-UP or START-UP After Automatic SHUT-OFFSafety Timers Harvest Sequence 5. Water PurgeHarvest Automatic SHUT-OFF 7. Automatic Shut-OffIce Machine Operation Section Operational Checks Water LevelICE Thickness Check Ice Thickness CheckWater Purge Adjustment Harvest Sequence Water PurgeIce Machine Operation Section Section Maintenance Exterior CleaningIce Machine Inspection Water-Cooled Condenser Water Regulating ValveMaintenance Section Guardian InstallationSachet Replacement Frequency Sachet Replacement ProcedureSection Maintenance Interior Cleaning and Sanitizing Cleaning ProcedureStep Maintenance Section Sanitizing ProcedureRemoval of Parts for CLEANING/SANITIZING Water Curtain Water Curtain Removal Ice Thickness ProbeIce Thickness Probe Removal Water Distribution Tube Water TroughWater Distribution Tube Removal Water Level Probe Water PumpWater Pump Removal Dump Valve Disassembly Water Dump ValveEvaporator Tray Removal Drain Line Check ValveWater Inlet Valve Maintenance Section Removal from Service/Winterization Pry Open the Water Regulating Valve AUCS→ AccessorySELF-CONTAINED WATER-COOLED ICE Machines Section Before Calling For Service ChecklistBefore Calling For Service Section Safety Limit FeaturePage Manitowoc ICE, INC