Ice-O-Matic ICE250 through ICE2100 SERIES manual How the ICE Machine Works

Page 19

ICE Series

How the ICE Machine Works

How the ICE Machine Works

A general description of how the ICE Series cubers work is given below. With the ICE/OFF/WASH switch in the ICE position, the compressor, water pump and condenser fan motor (when applicable) will energize starting the freeze cycle.

During the freeze cycle, water is circulated over the evaporator(s) where the ice cubes are formed. When the suction pressure has pulled down to the proper cut-in pressure of the timer initiate (pressure control), the contacts will close and energize the time delay module (timer). At this time the cubes will be close to completion.

The remaining portion of the freeze cycle is determined by the timer setting. The timer is pre-set at the factory to achieve the proper ice bridge thickness but may need to be adjusted upon initial start-up, see Page 15 for timer adjustment.

Once the amount of time on the timer has passed, the control relay will be energized and the machine will enter harvest. Power is now supplied to the water purge valve, hot gas valve, and the harvest motor.

The water purge valve opens, and allows the water pump to purge the water remaining in the water trough, removing impurities and sediment. This allows the machine to produce clear ice cubes and keep mineral build up at a minimum.

The hot gas solenoid opens allowing hot gas to go directly to the evaporator, heating the evaporator and breaking the bond between the evaporator and the ice slab.

The harvest assist motor, which is also energized during harvest, turns a slip clutch, which pushes a probe against the back of the ice slab. Once the evaporator has reached approximately 40°F (4.5°F) in temperature, the slip clutch overcomes the bonding of the ice to the evaporator and pushes the slab of ice off of the evaporator and into the storage bin.

The clutch also actuates a switch that rides on the outer edge of the clutch. When the clutch completes one revolution, the switch is tripped and the machine enters the next freeze cycle.

When ice drops into a full bin during harvest, the splash curtain is held open which activates a bin switch shutting the machine off. When ice is removed from the bin, the splash curtain will close and the machine will come back on.

Note: The ICEU150, 220, 225, 226, ICEU300 and 305 do not have a splash curtain. These models utilize a thermostatic bin control in place of a mechanical bin switch.

Page 14

Page 18 Page 20
Image 19
Page 18 Page 20
Contents ICE Series Cubers ICE Series Forward How To Use This ManualKeep this manual for future reference ICE Series Table of ContentsVisible Loss or Damage Freight Claims Important Inspect PromptlyConcealed Loss or Damage Filing a Claim ICE Series WarrantyLimitation of Implied Warranty Parts and LaborICE 040 0 H a Model and Serial Number FormatInstallation Guidelines ICE Series Air Flow Remote Condenser InstallationICE Machine Model Number Remote Condenser Model Number Formula for figuring maximum equivalent run is as followsElectrical and Plumbing Requirements ICEU150, 220, 225 Electrical and Plumbing Requirements ICEU300 ICE Series Electrical and Plumbing Requirements ICE0806 and ICE1006 Electrical and Plumbing Requirements 48 Inch Wide Cubers Electrical and Plumbing Requirements 22 Inch Wide Cubers Electrical and Plumbing Requirements ICE1606 Remote Electrical and Plumbing Requirements ICE1506 Remote How the ICE Machine Works Bridge Thickness and Timer Adjustment Start-Up ProcedureUndercounter Models Bin Control AdjustmentAdjustments are not covered under warranty Bin Control OperationGeneral Maintenance Procedure Ice Machine Cleaning and Sanitizing Instructions Cleaning Activity Cleaning Agent Cleaning stainless steelMethod of Application Winterizing Procedures Model NumberSerial NumberDate Installed ICE Series Service History
Top Page Image Contents