Ice-O-Matic ICE250 through ICE2100 SERIES manual General Maintenance Procedure

Page 22

ICE Series

General Maintenance

Electrical shock and/or injury from moving parts inside this machine can cause serious injury. Disconnect electrical supply to machine prior to performing any adjustments or repairs.

Failure to perform the required maintenance at the frequency specified will void warranty coverage in the event of a related failure. To insure economical, trouble free operation of the machine, the following maintenance is required every 6 months.

General Maintenance Procedure

To insure economical, trouble free operation of your machine, it is recommended that the following maintenance be performed every 6 months.

1.Clean the ice-making section per the instructions below. Cleaning should be performed a minimum of every 6 months. Local water conditions may require that cleaning be performed more often.

2.Check ice bridge thickness. See page 15 for proper thickness and adjustment procedure.

3.Check water level in trough. See page 15 for proper water level and adjustment.

4.Clean the condenser (air-cooled machines) to insure unobstructed air flow.

5.Check for leaks of any kind: Water, Refrigerant, Oil, Etc.

6.Check the bin control switch for proper adjustment. See page 16 for bin switch adjustment.

7.Check the water valve (water-cooled machines) for proper adjustment by measuring the water temperature at the outlet of the condenser. It should be between 100°F and 110°F. (38°C and 43°C)

8.Check all electrical connections.

9.Oil the fan motor if the motor has an oil fitting. (Self contained air-cooled models only)

10.Check the water filter (if applicable) and replace if dirty or restricted.

11.Inspect the evaporator water distribution tube to insure even water distribution of water across the face of the evaporator.

Page 17

Image 22
Contents ICE Series Cubers ICE Series Forward How To Use This ManualKeep this manual for future reference Table of Contents ICE SeriesVisible Loss or Damage Freight Claims Important Inspect PromptlyConcealed Loss or Damage Parts and Labor ICE Series WarrantyLimitation of Implied Warranty Filing a ClaimModel and Serial Number Format ICE 040 0 H aInstallation Guidelines ICE Series Remote Condenser Installation Air FlowFormula for figuring maximum equivalent run is as follows ICE Machine Model Number Remote Condenser Model NumberElectrical and Plumbing Requirements ICEU150, 220, 225 Electrical and Plumbing Requirements ICEU300 ICE Series Electrical and Plumbing Requirements ICE0806 and ICE1006 Electrical and Plumbing Requirements 48 Inch Wide Cubers Electrical and Plumbing Requirements 22 Inch Wide Cubers Electrical and Plumbing Requirements ICE1606 Remote Electrical and Plumbing Requirements ICE1506 Remote How the ICE Machine Works Start-Up Procedure Bridge Thickness and Timer AdjustmentBin Control Operation Bin Control AdjustmentAdjustments are not covered under warranty Undercounter ModelsGeneral Maintenance Procedure Ice Machine Cleaning and Sanitizing Instructions Cleaning Activity Cleaning Agent Cleaning stainless steelMethod of Application Winterizing Procedures ICE Series Service History Model NumberSerial NumberDate Installed