Ice-O-Matic ICE250 through ICE2100 SERIES manual ICE Series

Page 8

ICE Series

Installation Guidelines

Secure the machine on top of the bin or dispenser.

Attach the ice machine to the bin with the mounting straps provided with the bin or dispenser. If the ice machine is to be mounted on a bin or dispenser other than an ICE-O-Matic, refer to the manufactures instructions for machine mounting.

If the ice machine is to be stacked on top of another ice machine, a stacking kit will need to be installed. Refer to the installation instructions included with the stacking kit.

Important!

A water filtration system should be installed with all ice machines. Check the filter manufactures instructions for proper installation of the filter system.

All water supply lines must be installed per local codes. Use 1/4 inch O.D. minimum on air cooled machines. On water cooled machines 3/8 inch O.D. minimum tubing must be run to the condenser. The water supply for the ice making can “T” off from the condenser line using 1/4 inch O.D. minimum tubing. Make 2 coils of extra tubing so that the machine can be pulled away from the wall if service is needed.

All drain lines must be installed per local codes. The purge drain should be a minimum of 5/8 inch O.D. tubing. Condenser drain on water cooled units should be 3/8 inch O.D. minimum. Drain line fittings on ICE- O-Matic bins are 3/4 FPT. The bin drain should be a minimum of 3/4 inch O.D. Cold water drains should be insulated to prevent sweating.

Warning!

Do not apply heat directly to the back of bin as damage may occur to plastic parts.

Connect power supply to the terminal block in the control box or at the rear junction box if equipped.

Ensure the machine is level within 1/8 inch in all directions.

Remove any shipping or packaging material.

If the machine has a remote condenser, reference Remote Condenser Installation.

Once the machine has been installed follow the start-up procedures.

Attach the ice machine to the bin or dispenser with the provided mounting hardware.

Warning!

Do not apply heat directly to the back of bin as damage may occur to plastic parts.

Page 3

Image 8
Contents ICE Series Cubers Keep this manual for future reference How To Use This ManualICE Series Forward Table of Contents ICE SeriesConcealed Loss or Damage Freight Claims Important Inspect PromptlyVisible Loss or Damage ICE Series Warranty Limitation of Implied WarrantyParts and Labor Filing a ClaimModel and Serial Number Format ICE 040 0 H aInstallation Guidelines ICE Series Remote Condenser Installation Air FlowFormula for figuring maximum equivalent run is as follows ICE Machine Model Number Remote Condenser Model NumberElectrical and Plumbing Requirements ICEU150, 220, 225 Electrical and Plumbing Requirements ICEU300 ICE Series Electrical and Plumbing Requirements ICE0806 and ICE1006 Electrical and Plumbing Requirements 48 Inch Wide Cubers Electrical and Plumbing Requirements 22 Inch Wide Cubers Electrical and Plumbing Requirements ICE1606 Remote Electrical and Plumbing Requirements ICE1506 Remote How the ICE Machine Works Start-Up Procedure Bridge Thickness and Timer AdjustmentBin Control Adjustment Adjustments are not covered under warrantyBin Control Operation Undercounter ModelsGeneral Maintenance Procedure Ice Machine Cleaning and Sanitizing Instructions Method of Application Cleaning stainless steelCleaning Activity Cleaning Agent Winterizing Procedures ICE Series Service History Model NumberSerial NumberDate Installed