Manitowoc Ice Q130 manual Safety Limit #2

Page 37

Section 5

Before Calling for Service

 

 

Safety Limit #2

Harvest time exceeds 3.5 minutes for 3 consecutive harvest cycles.

Possible Cause

Check/Correct

Improper installation

See “Installation Instructions” Section 2 of this manual

Water system

Water area (evaporator) dirty

 

Water freezing behind evaporator

 

Low water pressure (20 psi minimum.)

 

Loss of water from sump area

 

Clogged water distribution tube

 

Dirty/defective water float valve

 

Defective water pump

Electrical system

Ice thickness probe out of adjustment

 

Ice thickness probe dirty

 

Bin switch defective

 

Premature harvest

Refrigeration system

Non-Manitowoc components

 

Improper refrigerant charge

 

Defective hot gas valve

 

TXV flooding (check insulation and bulb mounting)

 

Defective fan cycling control

Because there are many possible external problems,do not limit your diagnosis to only the items listed in these charts.

Part Number 000001130 12/08

5-5

Image 37
Contents Q130/Q210/Q270 UnderCounter Model Ice Machines Procedural Notices Safety NoticesRead These Before Proceeding Personal Injury PotentialTable of Contents Section Maintenance Table of Contents Section OperationSection Before Calling for Service Section General Information AccessoriesModel Numbers Q270 Models General Information Section Model/Serial Number LocationModel/Serial Number Location Ice Machine Model Number Serial NumberAuthorized Warranty Service Commercial Warranty Coverage GeneralService Calls GeneralGeneral Information Section Ice Machine Dimensions Section Installation InstructionsGeneral Q130/Q210 ICE MachinesIce Machine Heat of Rejection Installation Instructions Section Location of Ice MachineSeries Heat of Rejection Ice Machine Air Conditioning Peak Checking Ice Machine Level Section Installation Instructions Leveling the Ice MachineInstallation Instructions Section Electrical Service Water Supply Section Installation Instructions Water Service/DrainsWater Inlet Lines Drain ConnectionsTypical Water Supply Drain Installation Personal Injury Potential Installation Instructions Section Installation Checklist Component Identification OperationInitial START-UP or START-UP After Automatic SHUT-OFF Operation Section Ice Making Sequence of OperationSection Operation Energized Parts Chart Siphon System Operation Section Operational ChecksSiphon System Check Water Float Valve CheckWater Level Check Section OperationICE Bridge Thickness Check Ice Thickness CheckOperation Section Interior Cleaning and Sanitizing Section MaintenanceCleaning and Sanitizing Procedure Maintenance Section Q130 Water Distribution Tube Removal Q130 ModelsFloat Valve Removal Remove the Water Trough Remove the ice damper InstallationQ130 Q210/Q270Solution Type Water Mixed With Sanitizer Solution Type Water Mixed withRemove the Bin Door ICE Machine Inspection Exterior CleaningModel Amount of Sanitizer Air-Cooled Condenser Cleaning the CondenserWater-Cooled Condenser Water Regulating Valve SELF-CONTAINED AIR-COOLED ICE Machines Maintenance Section Removal From Service WinterizationWATER-COOLED ICE Machines Pry Open the Water Regulating ValveThis page Intentionally Left Blank Maintenance Section Checklist Section Before Calling for ServiceProblem Possible Cause To Correct Safety Limit Feature Before Calling for Service SectionSafety Limit Stand-By Mode Safety LimitsDetermining Which Safety Limit Stopped The Ice Machine Safety Limit NotesPossible Cause Check/Correct Safety Limit #1Safety Limit #2 This page Intentionally Left Blank