To adjust the rate (cont)
•The level in the liner should be one inch below the line where the liner ring attaches to the liner wall.
•
Fill Rate Adjustment
The fill rate depends on the water line pressure and the |
| |
opening of the FAST FILL VALVE, see figure 8. If the urn |
| |
does not refill as fast as it uses water during a brew cycle, you |
| |
may adjust the fill rate. If you adjust for maximum fill rate and |
| |
the level still cannot keep up, either the pressure is too low or | Figure 8, Fill Rate Valve | |
the fill system may have a clog. See Troubleshooting. | ||
|
To Adjust the Fill Rate:
•Remove the control access cover.
•Locate the needle valve labeled, FAST FILL VALVE.
•Open the valve a few turns.
•Brew water into both liners simultaneously. Watch the FILLING indicator.
•If the light cycles on and off, the rate is fast enough.
•If the FILLING light stays on, the rate is too slow.
|
|
American Metal Ware 67710E Coffee Urn | Page 14 |