Graco 310554V important safety instructions Mounting the Control Assembly

Page 12

Installing the Control Assembly

Mounting the Control Assembly (continued)

7.05

(171.1 mm)

16.00

(406.4 mm)

NOTE: Hidden lines depict the

hole pattern for mounting the control assembly.

NOTE: Conrol assembly must be readily accessible and located 24-67 in. (0.6-1.7 m) above the floor.

14.50

(368.3 mm)

16.00

(152.4 mm)

4x 0.13 in. (8 mm) diameter mounting holes

14.50

(368.3 mm)

7/8 in. diameter	Robot control	Motor cable
hole for power	cable connector	connector
supply entry.

FIG. 4

12

310554V

Image 12

Contents PrecisionSwirl Orbital DispenserList of Models Tool Mounted DispensersCable Assemblies Tool MountContents Equipment Misuse Hazard Skin Injection Hazard Fire and Explosion HazardToxic Fluid or Fumes Hazard 310554V Unpacking and Repacking Unpacking the ProductRepair and Repacking the Product PrecisionSwirl Overview PrecisionSwirl CapabilitiesPrecisionSwirl in Basic Robotic System No. DescriptionInstalling the Control Assembly Preparing to Install the Control AssemblyMounting the Control Assembly Electrocution HazardMounting the Control Assembly Installation Grounding the Control AssemblyFIRE, EXPLOSION, and Electric Shock Hazard Connecting the Control Assembly to a Power Source Electric Shock HazardDescription Requirements PE/GND Installing the Dispense Valve Connecting Air Lines to Dispense ValveConnecting Material Hose to Dispense Valve Mounting the Dispense ValveInstalling Cable Assemblies Connecting the Motor Control CableMotor Control Cable 15 ft Connecting the Automatic Control Cable Signal DescriptionVerifying Ground Continuity Verifying Ground ContinuityInspecting the Orbital Dispenser Grounding the SystemControl Assembly Controls Button/Switch What it does Control Assembly Indicators Button/Switch Light is MeaningPrecisionSwirl Module Operation Setting Operation Modes Analyzing Causes for a Motor Fault Alarm Using Automatic ModeAdjusting Orbital Dispenser Motor Speed Troubleshooting Troubleshooting Problem Cause SolutionControl Assembly Service Main Power Switch Removal Main Power Switch ReplacementPotentiometer Replacement Potentiometer RemovalPanel Assembly Service Swirl Control Board Replacement Swirl Control Board RemovalRFI Filter Replacement RFI Filter RemovalRelay Removal Relay Replacement Fuse Replacement Fuse RemovalControl Assembly Parts Part No. Description Qty8037B 13, 15 13, 53 42, 43 Part No , PrecisionSwirl Panel Assembly No. Part No. Description QtyControl Assembly Parts 310554V Accessory Parts Connection DiagramMotor Control Cable Assemblies SocketTorsional Motor Control Cable Assemblies Motor Control Cables Part Number Length DescriptionRobot Interface Cable Assembly Dispenser Valve Adapter FittingsWiring Diagrams Motor Controller Wiring, Lines Technical Data Control AssemblyGraco Standard Warranty Graco Information