Russound ST2-XM manual ST2-KP and CAV6.6 Connections

Page 10

ST2-XM SETUP AND CONNECTIONS

ST2-KP AND CAV6.6 CONNECTIONS

CAT-5 Cable

ST2-KP Connections to ST2-XM Tuner (Non-RNET Systems)

The diagram depicts a standard ST2-KP keypad connection to the keypad port on the back of the ST2-XM. The keypad uses a 110 punchdown connection and an RJ-45 T568A connection to the tuner.

UNO-S2 keypads

64:The Groove

ST2 Tuner

CAV6.6

RCA Cable

Source Connections with CAV6.6 Controller/Amplifier (RNET System)

The diagram depicts a typical setup using the ST2-XM Tuner with a CAV6.6 amplifier. Each tuner in the ST2 unit must be connected as a separate source for audio inputs. UNO-S2 keypads are connect- ed to the CAV6.6 keypad ports, NOT the ports on the ST2 Tuner.

10

Image 10
Contents Page Important Safeguards Safety InstructionsTable of Contents RNET-enabled System IntroductionBOX Contents Component Guide ST2-XM Front PanelST2-XM Rear Panel ST2 Smart TunerST2-RC Remote Control Seek UP/DOWNST2-XM Setup and Connections Basic ConnectionsST2-KP and CAV6.6 Connections ST2-KP Connections to ST2-XM Tuner Non-RNET SystemsSource Connections with CAi Series Controller/Amplifier Source Connections with A-BUS Audio Distribution HubAntenna Connections XM Signal Strength ModeConnecting an Indoor and Outdoor Antenna XM AntennaFM Antenna AM AntennaGrounding an Outdoor Antenna XM Radio Activation ST2-XM OperationXM Radio Overview XM Radio DisplaysXM Radio Modes XM Radio ModesFor all XM Modes Preset default Mode Category Search Mode 1.CAT Search Now Playing Mode 2.NOW Playng Display Preference Mode 3.DSPLY PrefFront Panel Controls Front Panel OperationFrequency Seek AM/FM only ST2-RC Remote Control OperationTurning the unit on/off Saving FavoritesST2-KP Keypad Controls ST2-KP Keypad OperationFrequency Scan AM/FM only UNO-S2 Keypad Controls with CAV6.6CAV6.6-UNO-S2 Keypad Operation MuteSelect UNO-LRC1 Remote Control with CAV6.6 UNO-LRC1 Remote Control OperationSelect Update Firmware Chassis ST2 Tuner Setup MenuST2 Chassis Setup Menu ST2-XM Tuner ProgrammingST2 Chassis Setup Procedures Factory Initialization ChassisXM Setup Menu Memory Name Procedure System Info ChassisXM Setup Menu Bank Name Procedure Tuner Setup Menu for XMMemory Name XM Controller ID XM Diagnostics XMBank Name XM Factory Initialization XMSystem Info XM Tuner Setup Menu for AM/FMMemory Name AM/FM Bank Name AM/FM Region AM/FMBackup and Restore AM/FM Setup MenuSource Configuration Note Programming for CAV6.6 USETechnical Specification ST2-XM Smart TunerWarranty & Repair Page Page Page Russound 28-1160 07/13/04