ST2-XM TUNER PROGRAMMING
ST2 TUNER SETUP MENU
Memory Name (XM) (continued)
9.Press BAND to advance. MEMORY NAME appears again.
10.Press BAND to access the Memory Name entry screen.
11.Press Tune Up/Down to select a character and MEM Up/Down to change a character position. Up to 12 characters can be entered one by one. A blinking cursor indicates the place- ment of the character being entered.
12.Press BAND when memory name is entered.
13.SAVE CHANGES will appear.
14.Press Tune Up/Down to select Yes or No.
15.Press BAND to save memory name. The Memory Name menu returns to the Memory # prompt to name other presets, or press TNR SEL to return to the Memory Name menu start.
Bank Name (XM)
A custom name can be assigned to each of the six banks of Tuner 1 (XM).
1.Enter the Setup Menu by pressing and holding the TNR SEL button.
2.TUNER SETUP appears. Press BAND.
3.MEMORY NAME appears. Press MEM Up/Down until BANK NAME appears on the tuner.
4.Press BAND.
5.Bank # appears.
6.Press the Tune Up/Down buttons to select the Bank #.
7.Press BAND. BANK NAME appears again.
8.Press BAND to access the Bank Name entry screen.
9.Press Tune Up/Down to select a character and MEM Up/Down to change a character posi- tion. Up to 12 characters can be entered one by one. A blinking cursor indicates the placement of the character being entered.
10.Press BAND when bank name is entered.
11.SAVE CHANGES will appear.
12.Press Tune Up/Down to select Yes or No.
13.Press BAND to save bank name. The Bank
Name menu returns to the Bank # prompt to name other banks, or press TNR SEL to exit the Bank Name menu.
Controller ID (XM)
The Controller ID procedure is used to identify the controller(s) that the XM tuner will respond to.
Note: For the XM module that is installed in the
Diagnostics (XM)
The Diagnostics procedure is for factory use only.
Factory Initialization (XM)
The Factory Initialization procedure allows the erasure of all programmed settings of the XM tuner and returns them to the factory default set- tings.
1.Enter the Setup Menu by pressing and holding the TNR SEL button.
2.TUNER SETUP appears. Press BAND.
3.MEMORY NAME appears. Press MEM Up/Down until FACTORY INIT appears on the tuner.
4.Press BAND to enter the FACTORY INIT menu.
5.“Are you sure” appears on the tuner. Using the Tune Up/Down buttons, view the “Yes” and “No” selections.
6.Press BAND to select. A “No” selection
returns to the top of the Factory Init menu. A “Yes” begins the initialization.
7.“Please wait” appears on the tuner during the process and “Cycle Power” appears when com- plete.
8.Cycle power on the
30