ST2-XM OPERATION
ST2-RC REMOTE CONTROL
ST2-RC Remote Control Operation
The
Turning the unit on/off
To switch the ST2 tuner in or out of standby mode,
PWR
push or any other button except TUNER 1 or TUNER 2.
Selecting the desired tuner
To control a tuner, push TUNER 1 or TUNER 2 . When pressed, these buttons will be backlit green for Tuner 1 (XM) and amber for Tuner 2 (AM/FM). Each time a tuner is selected the display will refresh with the cur- rent station or preset for that tuner, and all subse- quent button presses and memory preset entries will be associated with that selected tuner.
Selecting the desired band (AM/FM only)
Push | AM/FM | to switch between AM and FM reception. |
|
Selecting the desired frequency or channel
|
|
| TUNE |
Use | TUNE | and | for manual tuning. To move quickly |
through the stations or channels, press and hold either of the Tune buttons for more than 1.5 seconds.
To directly select a station or channel, press | TUNE | , |
|
and enter the two- or
Selecting a mode (XM)
Push OK to select an XM operating mode.
Exiting a mode (XM)
ST/
Push MONO to exit the XM operating mode selection menu.
Frequency Seek (AM/FM only)
The SEEK function is performed by pressing and
releasing 
to seek lower frequencies or 
for higher frequencies. SEEK tuning begins at the current frequency, seeks upward and stops at the next tuned
station. Pushing 
continues the SEEK function. Once the highest frequency is reached, the tuner con- tinues in SEEK mode at the lowest frequency.
Selecting Stereo or Mono Output (AM/FM only)
Press 
to toggle between stereo and mono mode. STEREO or MONO appears briefly on the screen when selecting mode. Normal operation is in stereo mode.
On a preset, the stereo/mono setting is saved for that preset.
Selecting Distant or Local Reception (AM/FM only)
Press 
to toggle between Distant and Local mode. DISTANT or LOCAL appears briefly on the screen when selecting mode. Normal operation is in Distant mode.
Recalling a Memory Preset
To recall a memory preset, select the desired tuner,
press | BANK | and enter the desired bank number | ||
| ||||
MEM | and enter the desired preset | |||
| ||||
number (1 to 6). The memory presets can also be
|
|
| MEM |
accessed by using | MEM | and | to scroll through all |
presets for the selected bank.
Saving Favorites
The remote control stores two “favorites” (similar to memory presets) per tuner. These are set simply by selecting either Tuner 1 or Tuner 2, setting the
desired frequency and pressing and holding FAV 1 or
until “FAV1 (2) saved” appears on the tuner. Stored Favorites are then recalled by pressing either
FAV 1 or FAV 2 .
20