Garmin 210 GEO T DL Electrical Connection, Hotplate, Grill, Oven check, Fitting the plinth

Page 24

Connect the pressure gauge. Turn on and light one of the hotplate burners.

For Natural Gas the pressure should be 20mbar. For Propane the pressure should be 37mbar.

Electrical Connection

This appliance must be installed by a qualified electrician to comply with the relevant regulations and also the local electricity supply company requirements.

WARNING: THIS APPLIANCE MUST BE EARTHED

Note

The cooker must be connected to the correct electrical supply as stated on the voltage label on the cooker, through a suitable cooker control unit incorporating a double pole switch having a contact separation

of at least 3mm in all poles. This cooker must not be connected to an ordinary domestic power point.

The total electrical load of the appliance is approximately 7.2 kW. The cable size used should be suitable for this load and comply with all local requirements.

Access to the mains terminal is gained by removing the electrical terminal cover box on the back panel.

Connect the mains cable to the correct terminals for your electrical supply type.

Check that the links are correctly fitted and that the terminal screws are tight.

Secure the mains cable using the cable clamp.

Hotplate

Check each burner in turn. There is a flame safety device that stops the flow of gas to the burner if the flame goes out. There is also a spark ignition system that works when the knob is pressed in.

For each burner, push in and turn the knob to the large flame symbol ( ).

The igniter should spark and light the gas. Keep holding the knob pressed in to let the gas through to the burner for few seconds.

If, when you let go of the control knob, the burner goes out, the safety device has not held in. Turn the control to

the off position and wait one minute, then try again this time holding in the control knob for slightly longer.

Grill

Open the grill compartment door. Turn on the grill control and check that the grill heats up.

Oven check

Turn on the ovens and check that they start to heat up. Turn off the ovens.

Fitting the plinth

Remove the 3 screws along the front bottom edge of the cooker. Hold the plinth in place and refit the 3 screws.

Main Door adjustment

Please check the aligment of the doors. The left hand Main oven has an adjustible hinge.

To Adjust the Oven Door Angle

The door bottom hinge can be adjusted to alter the angle of the door.

Loosen the bottom hinge fixing screws and use the notch and a flat bladed screwdriver to move the position of the hinge to set the hinge position.

Retighten the hinge screws.

Effect of hinge adjustment – exaggerated for clarity

Centre line of hinge pin

Oven door omitted for clarity

Customer care

Please inform the user how to operate the cooker and hand over these instructions.

Thank you.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Installation and Servicing Instructions User’s ManualInstallation Be safeGas and Electricity on Peculiar smellsContents Hotplate Burners Wok Centre Ring Wok CookingUsing the Grill Glide Out GrillGrill Cooking Chart Time minutesOvens Left Hand OvenRight Hand Tall Oven Multi-function oven functions Browning element Base heatBoth Ovens SteamMain Oven shelves Tall oven shelvesCooking chart Fan assisted oven function Falcon Multi-function Oven cooking guideEnsure meat and poultry is fully cooked before serving Oven Shelf Food Temp Position Approximate Cooking TimeOven Cooking chart Conventional and full Fan oven functions Approximate Cooking TimePosition Cleaning your cooker Stainless Steel HobHotplate burners Glide-OutGrillCleaning Brass Components Control Panel and Oven DoorsMain Oven Moving your cooker Tall OvenTroubleshooting General Safety Instructions If you smell gas0800 111 Take care that no water seeps into the appliance Installation Dear InstallerProvision of Ventilation Location of CookerPositioning the Cooker These are not supplied by with the cookerYou will also need the following tools Unpacking the Cooker Moving the CookerConversion to LP LevellingGas Connection Main Door adjustment Electrical ConnectionHotplate GrillConversion to LP Gas Servicing warningInjectors To convert the control tapsReassembly Natural Gas at 20mbarLP Gas Butane at 28-30 or Propane at 37mbar Burner ringsPressure Testing Stick on labelOuter Burners Check the appliance is gas soundServicing To Change an Ignition Switch To Replace a Grill ControllerTo Remove an Oven Cut-Off Thermostat To Remove a Hotplate BurnerTo Remove the Oven Outer Door Panel To Remove the Door LatchTo Remove the Oven Door Seal To Remove the Hotplate Spark GeneratorTo Adjust the Main Oven Door Angle To Remove an Oven fan ElementTo Remove the LH Oven Bottom and Top Elements To Remove a Grill ElementCircuit Diagram KeyTechnical Data DimensionsRatings ElectricPage Page ArtNo.000-0001 Aga address block

210 GEO T DL specifications

The Garmin 210 GEO T DL is an advanced GPS device designed for outdoor enthusiasts, allowing users to navigate with precision and ease. It combines topographical mapping, sophisticated navigation features, and rugged durability, making it a favorite among hikers, campers, and adventurers.

One of the standout features of the Garmin 210 GEO T DL is its high-sensitivity GPS receiver. This technology ensures accurate tracking even in challenging environments, such as dense forests or mountainous terrains, where signal loss can often be an issue. The device quickly locks onto satellites, providing real-time location data and ensuring that users can follow their routes confidently.

The screen of the 210 GEO T DL is notably user-friendly, featuring a high-resolution display that is easy to read even in bright sunlight. This is particularly beneficial for outdoor use, where visibility can be a challenge. Users can view detailed maps, waypoints, and track information, making the navigation process intuitive and straightforward.

Another important aspect of the Garmin 210 GEO T DL is its extensive mapping capabilities. The device comes preloaded with topographic maps, enabling users to explore diverse terrains without the fear of getting lost. The mapping system also supports the addition of custom maps, allowing users to personalize their navigation experience based on their specific needs and interests.

Battery life is crucial for outdoor equipment, and the Garmin 210 GEO T DL excels in this area. It boasts a robust battery performance, allowing for hours of continuous use. This is essential for long hikes or camping trips, where access to power sources may be limited.

Additionally, this GPS device includes features such as waypoint marking and route planning. Users can easily save locations of interest, such as campsites or scenic overlooks, and navigate back to them later. The built-in compass and barometric altimeter further enhance the outdoor experience, providing users with real-time information on their elevation and direction.

Overall, the Garmin 210 GEO T DL is a reliable and feature-rich GPS device tailored for those who appreciate the great outdoors. Its combination of advanced navigation tools, robust mapping capabilities, and durable design makes it an essential companion for any adventure, ensuring that users can explore with confidence and safety.
Top Page Image Contents