Manual tuning - FM
1.Fully extend the telescopic aerial. The aerial should be fully extended and positioned vertically for optimum reception.
2.Press the On / Off button to switch on your radio.
3.Press and release the Band button until the FM band is selected.
4.Press and release the Select button until the display shows 'Auto Scan: Off'.
5.Repeatedly press and release the Tuning Up or Down buttons to tune to a station. The frequency will change in steps of 50kHz.
If the radio is tuned to a station of sufficient signal strength with RDS information present, then the display may change to show the station name.
6.When the waveband end is reached the radio will recommence tuning from the opposite waveband end.
7.Adjust the Volume and Tone controls to the required setting.
8.To switch off your radio press the On / Off button.
Note: If you find that FM reception is poor, try repositioning the Telescopic aerial. Fully extend and position vertically for optimum reception.If you find that an FM broadcast has a lot of background hiss, this may often be reduced by setting the radio into Mono reception mode for the current FM station. Please refer to the section "Stereo / Mono setting - FM" on page 16 for further details.
3
4
5 5
77
If you need any further advice, please call our Technical Helpline on :- | 14 |
020 8758 0338 |