Miele KWT 1611 SF, KWT 1601 SF installation instructions Aligning the appliance

Installation

￿Plug the appliance into the power outlet ￿.

The plug of the appliance should be easily accessible after installation. If the plug is not accessible after the appliance has been installed, disconnection from the power supply should be completed via the circuit breaker.

In the case of side-by-side installations, a separate outlet must be used for each appliance.

￿To prevent the power cord from becoming caught:

Tie a piece of string to the middle of the power cord and feed it forward under the appliance. When sliding the appliance in, pull the cable forward ￿.

￿Carefully slide the appliance into the space until the height-adjustable wheels interlock with the anti-tip brackets ￿.

If resistance is felt when attempting to slide the appliance into the installation niche - for example, because the floor is uneven,

￿Turn the rear adjustable wheels slightly outward (see "Aligning the appliance"), then push the appliance in.

Be careful not to damage the power cord attached to the floor.

￿Remove the edge protector ￿.

Aligning the appliance

￿Align the appliance with the surrounding cabinets.

The height-adjustable feet at the front and rear can all be adjusted from the front:

–Front feet:

Adjust with a rachet 5/16" (8 mm) ￿

–Rear feet:

Adjust with a (cordless) screwdriver and/or a rachet 5/16" (8 mm) for fine adjustment ￿

Important!

When unscrewing the height-adjustable feet, proceed gradually, alternating between left and right.

51