Miele CS1028 installation instructions Burner, Reassembling the burner

Page 17

Cleaning and care

Burner

Reassembling the burner

Do not clean any parts of the burner in a dishwasher.

The burner can be dismantled and cleaned when cool.

￿Remove the burner parts and wash them in a solution of warm water and liquid dish soap. Dry them thoroughly. Make sure that the flame holes are clean and completely dry.

￿Wipe the burner base clean with a damp cloth and then dry.

Gently wipe the ignitor and ignition safety control with a slightly damp cloth, and then wipe dry.

Do not let the ignitor get wet. If it gets wet it will not spark.

￿After cleaning dry all surfaces with a clean cloth.

￿Place cover plate ￿ over burner base ￿ so that the ignitor and the ignition safety control extend through their respective holes in the cover plate. The cover plate must sit evenly over the burner base.

Do not use a warped cover plate.

￿Place the burner base in position above the cover plate making sure that pins ￿ slot into their respective holes in the burner head ￿.

￿Place burner cap ￿ in position.

Be careful not to mix up the parts.

17

Image 17
Contents Operating and Installation Instructions Gas Combiset What to do if YOU Smell GAS Contents Children Correct usageTechnical safety Safety Important Safety Instructions Review Them Periodically Guide to the combiset Burner Cleaning the combiset Before using the combisetTurning on OperationTurning on and off / Regulating Turning off Using the cooktop during a power failureAdjusting the flame Suitable pans PansPan size Ignition Safety Control Safety featuresCombiset Cleaning and careReassembling the burner Flame does not stay lit Possible fault Solution Frequently asked questionsIgniter does not spark Possible fault Solution Flame appears different than usual Possible fault SolutionTechnical Service MieleCare Installation Instructions Installation Safety distances above the appliance Not recommended Not allowed Safety distances to the sides of the applianceRecommended Safety distance from the wall covering InstallationInstallation dimensions Cut out Installation of multiple appliances Cut-out CountertopInstallation Wood or solid surface countertops Attach the spring clips and support barsGranite countertop Removing the appliance Installing the appliance / appliancesSealing Tiled surfaces Electrical connection Power supplyWiring Diagram Gas connection Gas pressure regulator Minimum output Gas type BTU/hr Nominal ratingsMaximum output Gas type BTU/hr Converting to another type of gas Disposal of an old appliance Help protect our environmentDisposal of packing materials Page