Miele CS1028 Installing the appliance / appliances, Removing the appliance

Page 33

Installation

Installing the appliance / appliances

￿Feed the power cord down through the cut-out.

￿Place the front edge of the appliance into the cut-out.

￿With a hand on each side of the appliance press down evenly on the edges until it clicks into position. When doing so make sure that the appliance seal sits tightly on the countertop to ensure it is sealed correctly. This is important to ensure an effective seal. Do not permanently seal into the countertop.

When installing more than one appliance, a sealing strip must be inserted into the support bar.

￿Push the installed appliance to the side until the slots in the support bar are visible.

￿Insert the sealing strip ￿ into the slots in the support bar ￿.

￿Place the front edge of the next appliance into the cut-out.

￿Connect the appliance / appliances to the main power supply (see "Electrical connection").

￿Turn the appliance / appliances on and check the function.

The appliance may be lifted out using a special tool.

The appliance can also be pushed up and out from underneath. Note: push the rear out first.

Removing the appliance

If the appliance is accessible from below, it can be pushed up and out of the cut-out. Push up from the back first.

If the appliance is not accessible from below, grip the appliance with both hands at the back, pull forward, then lift it up and out.

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Operating and Installation Instructions Gas Combiset What to do if YOU Smell GAS Contents Children Correct usageTechnical safety Safety Important Safety Instructions Review Them Periodically Guide to the combiset Burner Cleaning the combiset Before using the combisetOperation Turning on and off / RegulatingTurning on Using the cooktop during a power failure Adjusting the flameTurning off Pans Pan sizeSuitable pans Ignition Safety Control Safety featuresCombiset Cleaning and careReassembling the burner Flame does not stay lit Possible fault Solution Frequently asked questionsIgniter does not spark Possible fault Solution Flame appears different than usual Possible fault SolutionTechnical Service MieleCare Installation Instructions Installation Safety distances above the appliance Safety distances to the sides of the appliance RecommendedNot recommended Not allowed Safety distance from the wall covering InstallationInstallation dimensions Cut out Installation of multiple appliances Cut-out CountertopInstallation Wood or solid surface countertops Attach the spring clips and support barsGranite countertop Removing the appliance Installing the appliance / appliancesSealing Tiled surfaces Electrical connection Power supplyWiring Diagram Gas connection Gas pressure regulator Nominal ratings Maximum output Gas type BTU/hrMinimum output Gas type BTU/hr Converting to another type of gas Help protect our environment Disposal of packing materialsDisposal of an old appliance Page
Top Page Image Contents