IMPORTANT SAFETY INSTRUCTIONS
Technical safety
Installation, repair and maintenance work should be performed by a Miele authorized service technician. Work by unqualified persons could be dangerous and may void the warranty.
Before installing the combiset, check for externally visible damage. Do not operate a damaged appliance. A damaged gas combiset is a hazard.
Before installation, make sure that the voltage and frequency listed on the rating label correspond with the household electrical supply. This data must correspond to prevent injury and appliance damage. Consult a qualified electrician if in doubt.
Be certain your appliance is properly installed and grounded by a qualified technician.
To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. It is imperative that this basic safety requirement be met. If there is any doubt, have the electrical system of the house checked by a qualified electrician.
Install the appliance so that the power cord and gas piping do not come into contact with any portion of the combiset which may become hot during use.
Do not use an extension cord to connect this appliance to electricity. Extension cords do not guarantee the required safety of the appliance.
Do not operate the appliance until it has been properly installed in the countertop.
Do not operate any appliance with a damaged cord or plug, or if the appliance has been damaged in any manner. Contact Miele’s Technical Service Department.
Defective components should be replaced by Miele original spare parts only. Only with these parts can the manufacturer guarantee the safety of the appliance.
Under no circumstance open the outer casing of the appliance.
While the appliance is under warranty repairs should only be performed by a Miele authorized service technician. Otherwise the warranty is void.
5