Vulcan-Hart VP18 ML-138089 operation manual General, Introduction, Installation, Unpacking

Page 4

V SERIES HOLDING, TRANSPORT & PROOFING CABINET

F-41190 (09-10)

GENERAL

INTRODUCTION

Vulcan-Hart Holding & Transport and Proofing Cabinets are produced with quality workmanship and material. Proper installation, usage, and maintenance of your cabinet will result in many years of satisfactory performance.

It is suggested that you thoroughly read this entire manual and carefully follow all of the instructions provided.

Carefully unpack and place in a work accessible area as near the installation position as possible.

1.Open the door and carefully remove any packaging materials. Remove 20 Tray Slides and 2 Water Pans. (10”x12”x2½”)

2.Peel off all vinyl protection film.

3.Install desired number of Tray Slides. Make sure the hook on the end of the tray slide is up.

(Fig. 1)

INSTALLATION

Before installing, verify that the electrical service agrees with the specifications on the rating plate located on the lower back corner of the cabinet. (Fig. 4) If the supply and equipment requirements do not agree, do not proceed with unpacking and installation. Contact your Vulcan-Hart Customer Service Department immediately.

UNPACKING:

The Cabinet was inspected before leaving the factory. The transportation company assumes full responsibility for safe delivery upon acceptance of the shipment. Immediately after unpacking, check for possible shipping damage to the cabinet.

If the cabinet is found to be damaged, save the packaging material and contact the carrier within 15 days of delivery.

(Fig. 1)

4.Insert one (1) Water Pan in opening at the bottom of the cabinet and insert one (1) Water Pan through slides underneath the cabinet. (Fig. 2)

WATER PAN

WATER PAN

(Fig. 2)

3

Image 4
Contents Installation ModelImportant for Your Safety For Your SafetyTable of Contents Installation GeneralIntroduction UnpackingCleaning Electrical RequirementsLocation Electrical ConnectionsControls OperationHold Proofing Operating Instructions Dough Preparation Proofing ShutdownProofing Guideline Holding Operating Instructions Holding ShutdownCleaning Stainless Steel CareLockout / Tagout Procedure MaintenanceHeat Tint Service & Parts Information TroubleshootingSymptoms Possible Causes Remedy Specifications Capacity Dimensions Electrical WeightWiring Diagram

VP18 ML-138089 specifications

The Vulcan-Hart VP18 ML-138089 is a state-of-the-art commercial cooking appliance designed for efficiency and durability in bustling kitchen environments. This versatile piece of equipment is particularly suited for restaurants, cafeterias, and other food service establishments where high-volume production is essential.

One of the standout features of the VP18 is its exceptional performance capabilities. The unit is designed to provide even heating across its cooking surface, ensuring that food is cooked thoroughly and uniformly. This advantage is critical for maintaining quality and consistency in food preparation, especially when dealing with large batches.

The Vulcan-Hart VP18 is equipped with powerful burners that deliver quick heating responses. The burners are built with advanced technology that enhances fuel efficiency while maximizing output. Operators benefit from the ability to control temperatures precisely, which is essential when cooking a variety of dishes that require different heat levels.

In addition to its performance, the VP18 boasts a sturdy construction made from high-quality stainless steel. This not only contributes to the appliance's durability but also makes it easy to clean and maintain. The surface resists corrosion and stains, ensuring that the equipment looks professional even after extended use.

The VP18 comes with a variety of accessories, including cast-iron grates and a built-in grease collection system. These features further enhance its functionality, enabling chefs to prepare a wide range of foods, from sautéed vegetables to grilled meats, with ease. Moreover, the appliance's design prioritizes safety, with features that mitigate risks associated with high-heat cooking environments.

Another notable aspect of the Vulcan-Hart VP18 ML-138089 is its energy efficiency. The unit is designed to minimize gas consumption without compromising on power, making it an environmentally friendly choice for restaurants looking to lower their operational costs.

The VP18 is also designed with ease of use in mind. Intuitive controls allow kitchen staff to adjust settings quickly, ensuring a seamless workflow in busy kitchen scenarios. The appliance's compact size also makes it a practical option for establishments with limited kitchen space.

In summary, the Vulcan-Hart VP18 ML-138089 is a top-tier cooking appliance that combines robust performance, durability, and ease of use. Its advanced features make it an indispensable tool for any commercial kitchen aiming to deliver high-quality meals efficiently. With its focus on innovation and reliability, the VP18 stands out as a leader in commercial cooking technology.