GE RB787 warranty ANTI-TIP Device, All ranges can tip Injury could result, Tools needed

Page 36

ANTI-TIP DEVICE

WARNING

• All ranges can tip.

• Injury could result.

•Install the Anti-tip device packed with the range.

• See the Installation

Instructions.

STABILITY DEVICE INSTALLATION INSTRUCTIONS FOR BRACKET KIT NO. 342473

Tools needed:

•Phillips head screwdriver

•13⁄8″ open end or adjustable wrench

The bracket attaches to floor or wall to hold either the right or left rear leg leveler. If fastening to the floor, be sure that the screws do not penetrate electrical wiring or plumbing. If this cannot be determined, use shorter screws that will not penetrate through flooring.

The bracket is packed inside the oven. Remove and follow the instructions below.

1.Decide whether the bracket will be installed on the right or left side of the range location.

2.If the bracket side of the range is adjacent to a cabinet, place the bracket against back wall and cabinet as shown in Figure 1.

If there is no adjacent cabinet, determine where the location of the range side (painted outside panel) will be. Place the bracket with its outside edge at this location and against the back wall. See Figure 1.

3.Determine whether you will anchor the bracket to the floor or wall. Fasten the bracket securely with the screws provided. The screws are self-drilling in wood, plywood, particle and chip board, and most metal framing. If attaching to masonry you can buy suitable screws and anchors at hardware stores. Use a masonry drill to drill the required holes.

4.Using the wrench, back out the four leg levelers at least two turns. See the Installation Instructions for more leveling information before positioning range.

5.Slide the range into place. Be sure the rear leg leveler fully engages the slot in the bracket. If the range cannot be moved back far enough for the rear leg leveler to enter the bracket, move the bracket forward as required and attach to the floor in the new location.

Bracket

Wall Plate

Adjacent cabinet or final location

of range side panel

Make sure leg leveler engages slot

Outside edge of bracket to be flush with left or right side of range

Wall behind range

Fig. 1

Screw must enter wood

or metal

Attachment to wall

36

Image 36

Contents Your Range If YOU Need SERVICE… Help US Help YOU…Important Safety Instructions Important Safety InstructionsSelf-Cleaning Oven OvenSave These Instructions Cooktop and Radiant Surface UnitsFeatures of Your Range Explained Oven Vent Duct Cooktop Surface Units Hot Surface LightBroil Element Oven Shelf SupportsPreparation HOW does this Cooktop Compare With Your OLD ONE?Flooring Under the Range Leveling the RangeHot Surface Indicator Light CooktopComparison General Information About Radiant Surface UnitsHow to Set the Controls Cooking Guide for Using Heat SettingsSurface Controls How to Check Pan Performance Surface Cookware TipsSurface Controls TipsDeep Fat Frying ProofHome Canning Tips SurfaceCookware Tips Home Canning Tips Observe the Following Points in CanningSurface Cleaning Glass Ceramic Cooktop CleaningFor heavy, burned on soil Store the razor blade out of reach of children Special CareFeatures of Your Oven Control Features of Your Oven ControlOven CONTROL, Clock and Timer Power Outage Oven Temperature KnobPreheated light glows when the oven Using Your Oven Using Your How to Set Your Range for BakingBaking OvenPan Placement PreheatingBaking Pans Baking GuidesPies CakesAluminum Foil Don’t PeekHow to Time Bake How to Set Immediate Start and Automatic StopTimed Baking How to Set Delay Start and Automatic Stop Questions and AnswersTimed Baking Adjust the Oven Thermostat Do IT YourselfAdjust the Oven How to Set Your Range for RoastingRoasting Thermostat RoastingWhy is my roast crumbling when I try to carve it? Roasting GuideFrozen Roasts How to Set Your Range for Broiling BroilingBroiling Broiling Guide Oven door should be open to the broil stop positionOperating the SELF-CLEANING Oven Cleaning OvenBefore a Clean Cycle Broiling GuideHow to Set the Oven for Cleaning To Stop a Clean CycleAfter a Clean Cycle Door lock mechanismOperating the Self-Cleaning Oven How to Set Delay Start of CleaningShould there be any odor during the cleaning? Why do I have ash left in my oven after cleaning?My oven shelves do not slide easily. What is the matter? Care and Cleaning Care and CleaningOperating the Self Control Panel and KnobsBroiler Pan and Grid Lift-Off Oven DoorInside of the door Outside of the doorCleaning Removable Storage DrawerOven Interior Light Painted SurfacesSee the Installation Instructions ANTI-TIP DeviceAll ranges can tip Injury could result Tools neededQUESTIONS? USE this Problem Solver Anti-Tip Device Problem SolverThis is normal. Make sure flat-bottomed pans are used Problem Solver Not WorkWe’ll Be There Warranty