GE JP385 Coil Surface Unit Module, How to Insert the Module, How to Remove the Module, Cookware

COIL SURFACE UNIT MODULE

How to Insert the Module

1.Be sure the controls are turned to OFF. To install the module, position the plug to the outside wall of the cooktop.

2.Slide the module toward the outlet in the side of the cooktop until the plug is pushed all the way in.

3.Lower the inside edge of the module into the cooktop until it is flush with the cooking surface.

How to Remove the Module

1.Be sure the controls are turned to OFF and the surface units are cool before attempting to remove the module.

2.Lift up the tab at the inside edge of the module until the base clears the opening at the side of the cooktop.

3.To unplug, hold the module by the front and back edges and slide toward the center of the cooktop. Lift out when unplugged.

4.If you are storing modules, do not stack them or store other materials on top of them. This could damage the surface of the modules.

Cookware

Use medium- or heavy-weight cookware. Aluminum cookware conducts heat faster than other metals. Cast-iron and coated cast-iron cookware are slow to absorb heat, but generally cook evenly at low to medium heat settings. Steel pans may cook unevenly if not combined with other metals.

For best cooking results pans should be flat on the bottom. Match the size of the saucepan to the size of the surface unit. The pan should not extend over the edge of the surface unit more than 1 inch.

Always read and follow cookware manufacturer’s instructions on cookware use.

Right Wrong

Not over 1 inch Over 1 inch

10