GE PDE9900 manual Demo Mode, Wash Cycles

Demo Mode

•Demo mode is entered by pressing the Cookware pad (down arrow pad on Top Control models) and Added Heat pad simultaneously for 5 seconds.

•When entered, the Normal and Added Heat LEDs blink for 3 seconds, and the active vent will close.

•Pressing a pad will light the corresponding LED.

•Pressing the Start/Reset pad will activate the main pump for 20 seconds, and each cycle LED will be lit in sequence for 3 seconds (left to right).

•The display will sequence 999, 888, 777, 666, 555, etc., before running the main pump.

•The cycle will end after the main pump stops. The drain cycle will not be energized.

•To exit the demo mode, the dishwasher must be disconnected from power.

Wash Cycles

	CYCLE	MAX # OF	WASH	MAX #	WASH TIME1		WASH TEMPERATURE		HEATED	FAN ON TIME6
		PRE-WASH	CYCLE	RINSE					DRY TIME
					MIN	MAX	MIN	MAX		HEATED DRY	W/O HEATED DRY
		CYCLES		CYCLES
Normal Wash		3	1	3	36	99	1372	1452	38+5	158	240
Speed Wash		3	1	2	23	53	1303	1503	8	128	240
China Crystal		2	1	3	26	61	1303	1353	30	150	240
Pots & Pans		4	1	3	60	112	1502	1402	38	158	240
Sani Wash		3	1	3	36	115	1303	1583	15+154	150	240
Plastics		3	1	2	76	136	1402	1452	45/605	180	240
Glasses		2	1	3	26	61	1303	1403	30	150	240
Single Rack Wash		3	1	3	36	96	1372	1452	38	158	240
Rinse Only		2	0	0	9	11	_	_	_	_	240
Time is in minutes
Temperature is in degrees Fahrenheit
1.)	Cycle times do not include water fill and drain
2.)	Heater on in main wash and final rinse
3.)	Heater on in all pre-washes, main wash, and all rinses
4.)	Heated dry time and cool down time
5.)	45 minutes without heated dry, 60 minutes with heated dry
6.)	Fan running time after cycle has completed

– 26 –