GE PDE9900 manual SmartDispenseTM, Detergent Reservoir, To remove the reservoir

Page 15

SmartDispenseTM

SmartDispenseTM is a bulk liquid detergent dispense assembly consisting of the following components:

•Detergent Reservoir - Mounted within the inner door panel

•Detergent Level Sensor - Connected to a Low Detergent LED on the control panel

•Positive Displacement Pump - Injects the optimal amount of detergent into the dishwasher during each cycle.

Detergent Reservoir

Note: The SmartDispenseTM system can only be used with liquid or gel automatic dishwasher detergent.

To fill the reservoir, push down on the cap covering the reservoir to engage the ratchet, then turn it counterclockwise to open.

Position the door at a 30 to 45 degree angle. Fill the reservoir with a liquid automatic dishwasher detergent until the detergent reaches the threads of the reservoir access. The dispenser will hold approximately 45 ounces of liquid dishwasher detergent (about 1 to 2 months supply).

Place the cap on the reservoir access threads, push down, then turn clockwise until the cap is tight.

To remove the reservoir:

Note: Removing the reservoir access collar causes structural damage to the collar. It must be replaced with a new part # WD35X10059.

Remove the door panel. (See Door Panel.) Insert a small flat-blade screwdriver into the slot in the side of the retaining collar and push the screwdriver handle counterclockwise while turning the reservoir access collar counterclockwise a quarter turn. Remove the retaining collar. Unplug the tube from the reservoir outlet and disconnect the sensor from the control module.

Note: The dispenser tank comes as an assembly. It includes the sensor with wire harness, gasket, and retaining collar. The complete assembly part number is WD35X10058.

– 15 –

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Technical Service Guide Important Safety Notice Table of Contents Serial Number NomenclatureW 9 9 8 0 L 0 0 S S Model NumberIntroduction PDW8900 Series Control FeaturesSelections Enhancements Start PDW8900 Series Shown Door View Component Locator ViewsPDW8900 Series Shown Inside Cabinet View Left Side ViewRear of Dishwasher PDW9000 Series ShownPDW8900 Series Shown Bottom View Front of DishwasherDishwasher Components Door Panel PDW9700 Series and PDW9900 SeriesPDW8900 Series Keypad Assembly PDW9700 Series and PDW9900 Series Front Mount Control PDW8900 Water Hardness Test and Calibration Test Water HardnessSmartDispenseTM Calibration Water Hardness Test Strip IndicationSmartDispenseTM Detergent ReservoirTo remove the reservoir Detergent Level Sensor Positive Displacement Pump Approximate Detergent UseTo remove the pump When to Purge the Bulk Dispenser Tank Customer Purge of the Bulk Dispenser TankConsumer Purge Cycle Door Interlock Switch Detergent/Rinse Modulefirst time the module is activated Using the Dishwasher with the Upper Rack Removed Removal and ReplacementMiddle Spray Arm Lower Spray Arm, Fine Filter, and Inlet Cover Upper Spray ArmMain Conduit Fill FunnelHeating Element Turbidity Sensor TestCalibrating the Turbidity Sensor Drain System Smart Fill System Water Valve Test Water Valve and Flood SwitchWash Cycles Demo ModeControl Module Board Control ModuleActive Vent Normal Wash Cycle Single Rack WashTMWax Motor and Magnet Circulation Pump and MotorDoor Spring Installation Description Time Service ModeEntering Factory Test Mode Factory Test ModeVerify operation after Schematics and Strip CircuitsPDW9900 Series PDW9700 SeriesFor The Period GE Will Replace Warranty for 2005 ProductFor The Period GE Will Replace Warranty for 2006 and Later Product
Top Page Image Contents