GE L0523252 installation instructions Istep 141 Connect Power, Supply, PRE-TEST Checklist

Installation Instructions

ISTEP 141 CONNECT POWER

SUPPLY

Skip this step if equipped with power cord,

Verify that power is turned off at the source.

•Remove junction box cover "A".

•Locate the three dishwasher wires, (white, black and green) with stripped ends. Insert dishwasher wires through the small hole in the junction box "B".

•Secure house wiring to the bottom of the junction box with a strain relief "C".

•Use wire nuts to connect incoming ground to green, white to white and black to black "D".

•Replace junction box cover "E". Checkto be sure thatwires are not pinched under the cover.

A	B CheckThat White, Blackand
Remove	GreenDishwasher Wires Are Threaded
Junction Box
	Thru Hole in Back
Cover
		White
	Ground
	, /	!i/Black

D Use UL Listed

Wire Nuts

g

Insert Power

CordWires Thru

Strain Relief

and Tighten

FigureY

E. Replace Junction Box Cover

If house wiring is not 2-wire with

ground, a ground must be provided WARNINGby the installer. When house wiring is aluminum, be sure to use UL Listed

anti-oxidant compound and aluminum- to-copper connectors

I STEP 15] PRE-TEST CHECKLIST

Review this list after installing your dishwasher to avoid charges for a service call that is not covered by your warranty.

[] Check to be sure power is OFE

[] Open door and remove all foam and paper packaging.

[] Locate the Owner'sManual in the literature

package.

[] Read the Owner'sManual for operating instructions.

[] Check door opening and closing. If door does not open and close freely or tends to fall, check spring adjustments. See Step 1.

[] Check to be sure that wiring is secure under the dishwasher, not pinched or in contact with door springs or other components. See Step 9.

[] Check door alignment with tub. If door hits tub, level dishwasher. See Step 10.

[] Pull lower rack out, about half way. Check to be sure it does not roll back or forward on the door.

If the rack moves, adjust leveling legs. See Step 10.

[] Check door alignment with cabinet. If door hits cabinet, reposition or relevel dishwasher. See Step 10.

[] Verify water supply and drain lines are not kinked

or in contact with other components. Contact with motor or dishwasher frame could cause noise.

See Step 8.

[] Turn on the sink hot water faucet and verify water

temperature. Incoming water temperature must be between 120°F and 150°E A minimum of 120°F

temperature is required for best wash perfor- mance. See "Prepare Hot Water Line," page 5.

[] Add 2 quarts of water to the bottom of the dish- washer to lubricate the pump seal.

[] Turn on water supply. Check for leaks. -tighten connections if needed.

[] Remove protective film if present from the control panel and door.

11