GE PDW9200, PDW8100, PDW9800 manual Flashing display lights, Recommended dishwasher products, Clean

www.GEAppliances.com

6 Clean

PDW8100–PDW8800 Series

The CLEAN light is illuminated when the selected cycle and enhancements are complete. The light will stay ON until the door is opened.

PDW9200–PDW9800 Series

The CLEAN light is illuminated and a double beep will sound when the selected cycle and enhancements are complete. You may remove the dishes at any time. Note the high-efficiency fan will run quietly for 30 minutes to 4 hours (depending on selected cycle) after the CLEAN light is illuminated to continue drying the dishes. This can be interrupted by opening the door and pressing any keypad.

NOTE: To turn off the double beep indicator (or re-activate it if it was previously disengaged), press the HEATED DRY pad 5 times within 3 seconds. A triple beep will sound to indicate the end-of-cycle beep option has been toggled.

Flashing display lights.

Status Indicator Lights	What It Means
START/RESET	Cycle has been interrupted by pressing the START/RESET pad. Light will
	quit flashing after the dishwasher automatically drains out the water.

Recommended dishwasher products.

Safety Instructions

Operating Instructions

GE recommends the following products for use in its dishwashers:

■Electrasol,® Cascade® and Cascade Complete™

Dishwasher Detergents.

■Jet Dry® and Cascade Rinse Aid® to remove spots and prevent new film buildup on your dishes, glasses, flatware, cookware and plastic.

■Cascade® Plastic Booster™ to remove red staining inside your dishwasher that can come from some tomato-based stains.

■Cerama Bryte® Stainless Steel Appliance Cleaner to clean the stainless steel panel of GE and Profile™ stainless exterior dishwashers.

■Jet Dry® Dishwasher Cleaner to help remove some hard water mineral stains that can occur in hard water conditions.

Troubleshooting Tips

Consumer Support

7