Fisher & Paykel RF175W, RF195A EN 10 Installation instructions, Installation all models

EN 10 Installation instructions

5. Installation (all models)

Your Fisher & Paykel Active Smart™ refrigerator is fitted with front and rear rollers, designed for moving the product in the forwards and backwards direction.

Avoid moving the product in a sideways direction as this may damage the rollers or the floor covering/ surface.

1Your refrigerator will arrive with the front leveling feet wound up making moving this product into its final location a simple task.

2Roll the refrigerator into its final position making sure there is the correct air gap between the product and the surrounding cabinetry. See minimum clearance in cabinetry dimensions table (refer to page 7).

3Using a hex headed screwdriver, or socket set,

turn the front adjustment screws ( a ) clockwise
to raise the product and counterclockwise to
lower the front of the refrigerator.	a	a
		Fig.3 Adjustment screws

4Ensure product is sitting backward with the front approximately ⁄” (10 mm) higher than the back. This will ensure a good door-closing action.

5Align your refrigerator with cabinetry:

a Align the sides of the refrigerator with cabinetry by adjusting the right-hand side adjustment screw.

b Adjust the left-hand side adjustment screw until it touches the floor and takes a small amount of weight.

cOnce the refrigerator is in place and aligned

with the cupboards/alcove, push gently on the
front top and check if the product is rocking or
stable. If the product is rocking, refer to steps
7 – 10.	Fig.4 Toe grille installation

dIf the product is stable and no door leveling is required, place toe grille onto the bottom of the product (refer to figure 4):

Align the toe grille mounting clips with the lower cabinet slots.

Push the toe grille firmly until it snaps into place.