Installation instructions 11 EN
6. Leveling the refrigerator door (RF195A only)
6 If doors are uneven, do the following: |
| |
a | Determine which door needs to be raised. |
|
b | Turn the front roller adjustment screw ( a, Fig.3 ) on that |
|
| side clockwise to raise front corner of door. |
|
c | If one adjustment screw has reached the limit of its |
|
| adjustment range and the doors are still not level, lower |
|
| the opposite door by turning the roller adjustment screw |
|
| counterclockwise. |
|
d | Check with level to verify ⁄” (10 mm) tilt to the back for |
|
| proper door closure. |
|
e | Once refrigerator is aligned, screw feet firmly in place and | Fig.5 Uneven door alignment |
|
| |
attach toe grille (refer to step 5d).
7. What to do if the product is unstable (all models)
7Gently pull the refrigerator forward and screw down the feet until they make contact with the floor.
8Push the refrigerator back until the rear rollers contact the floor.
a Measure the gap under the front foot, which has come off the floor.
b Obtain some solid packing material (hardwood, plastic, etc), which fits firmly into the gap under the foot.
Note: do not use metallic materials that may corrode, stain and/or damage floor coverings.
Example only
This foot lifts off the floor when top front is gently pushed back
Fig.6 Unstable refrigerator