EN 12 Installation instructions
9Wind both front feet up and roll the product out of position.
a Place the packing material in the location diagonally opposite the front roller that lifts off the floor.
b Make sure the packaging material stays in place when the product is pushed back into position.
c Ideally, the packing material is large enough to rest against the back wall so as to prevent it moving when the cabinet is pushed into position.
10Roll the refrigerator back into position and adjust front rollers as per step 5 (check alignment and door closing action are satisfactory).
a Make small adjustments to front rollers where necessary.
b Firmly screw front feet down on the ground.
c Check that the product is stable (all 4 feet are on the floor). If not, return to step 7 and repeat
8, 9 and 10.
d Place toe grille on the bottom of the refrigerator (refer to step 5d).
Packing material goes under rear roller diagonally opposite front foot that lifts
Wall behind refrigerator
This foot lifts off the floor when pushing gently on the top front of the refrigerator
Fig.7 Stabilizing your refrigerator