U-Line ICE-MAKER/REFRIGERATOR user manual BUILT-IN Installation, Unit Dimensions

User’s Manual

NOTE

Use care not to bend light switch bracket (where installed), located on door bottom when installing door insert. Do not set door on bottom edge when pushing insert into place.

6.Slide custom door panel insert into 1/4 inch channel in door front.

7.Holding door gasket out of the way, replace handle on door mak- ing sure it is seated properly on insert and that screw holes line up.

8.Install two small screws removed in step 3.

9Starting at the center and working outward, push door gasket into place on door.

10.Place door on bottom hinge pin and install upper hinge screw (see Figure 25).

BUILT-IN INSTALLATION

Your U-Line product has been designed for either free-standing or built- in installation. When built-in, your U-Line product does not require addi- tional air space for top, sides, or rear. However, the front grill must NOT be obstructed.

NOTE

Combo Models 29A, 29FF, 75A, and 75FF require addi- tional clearance when the door opens from the right (see Figures 29 and 30). This additional clearance allows for the ice bucket to be removed from the unit.

Unit Dimensions

Model	Width	Height	Depth
SP18	13-15/16"	18-1/2"	25-1/4"
95	13-13/16"	24-3/4"	17"
98	14-13/16"	27-3/8"	20"
15 Series	14-15/16"	34 - 35"	23-3/4"
29 Series	20-13/16"	28-1/2"	24"
75 Series	23-7/8"	34 - 35"	24"

NOTE

To ease unit installation and removal, increase the above measurements. It is recommended that the cabinet rough opening dimensions be increased by at least 1/4" over the dimensions given for your unit.

18