Install the insert as follows:
!WARNING
Insert edges may be SHARP! Use care when installing.
1.Remove top hinge screw pin (large Phillips head, see Figure 25). Hold door to keep it from falling.
2.Remove door, being careful not to scratch top of door on hinge.
3.Remove two small screws holding door handle. Slightly separate door handle from door (see Figure 26).
UL132
| UL131 |
Figure 25 | Figure 26 |
4.Pull door gasket out of groove (top edge of door only). Start in the middle and pull outwards, moving towards the edge (see Figure 27). This may take some force.
5.Pull handle up and off.
UL117
Figure 27
17 
