Using the Self Clean mode
1Remove oven shelves, shelf supports (see ‘Cleaning’) and all other cookware/utensils from the oven before using the Self Clean mode.
2Select the Self Clean mode by turning the oven mode dial.
3Select the maximum temperature using the temperature dial, will appear in the display
and this will change to when the cycle begins. The DOOR LOCK and CLEAN symbols will show in the clock display and the time remaining will count down.
For your safety the door lock will automatically activate once the Self Clean mode and temperature has been selected.
4At the end of a self clean cycle, the door will unlock and the DOOR LOCK symbol will
disappear. The CLEAN symbol and will flash in the clock display and in the mode display until the oven is returned to manual operation - To do this turn the oven mode and temperature dials to ‘OFF’.
5At the completion of the self clean cycle, you will notice grey ash deposited inside the oven. The amount of ash in the oven is dependent on the amount of soil present in the oven before it was cleaned. When the oven is completely cooled, the ash is easily removed with a small brush or dry cloth, then wipe out the oven with a clean damp cloth and dry with a clean
6Replace the shelf supports (see ‘Cleaning’) and oven shelves.
To cancel the Self Clean mode before it has finished
Turn the oven mode and temperature dials to ‘OFF’. will appear in the oven mode display and the door will remain locked until the oven has cooled to a safe temperature.
Do not turn the power to the appliance off as the fans are necessary to cool the oven.
If the oven is cool or below the safe temperature it will return to normal operation and the clock display will show the time of day.
Short Self Clean cycle
A shorter self clean cycle can be selected if the oven is only lightly soiled:
1Select the Self Clean mode by turning the oven mode dial.
2Select the maximum temperature using the temperature dial.
3While is shown in the display, press the button. The COOK TIME and AUTO symbols and the colon will flash.
4Rotate the Setting Selector dial to reduce the time; this can be anywhere between two and three hours.
5Press the button again or wait eight seconds to adopt the setting and start the self clean cycle. The clock display will show the time remaining.
37