Fisher & Paykel OR90SDBSI Fitting the anti-tilt bracket, To fit the anti-tilt bracket

Fitting the anti-tilt bracket

Important!

To restrain the appliance and prevent it tipping accidentally, fit a bracket to its rear to fix it securely to the wall.

For New Zealand and Australia only: make sure you also fit the supplied lock pin to the anti-tilt bracket.

If installing the cooker above a plinth (without fitting the adjustable feet), revise the installation dimensions accordingly considering that the feet have the following measures: min 155 mm - max 180 mm.

To fit the anti-tilt bracket:

1After you have located where the cooker is to be positioned, mark on the wall the place where the two screws of the anti-tilt bracket have to be fitted. Please follow the indications given in Fig10a.

2Drill two 8 mm diameter holes in the wall and insert the plastic plugs supplied.

Important!

Before drilling the holes, check that you will not damage any pipes or electrical wires.

3Loosely attach the anti-tilt bracket with the two screws supplied.

Installation instructions 9

898 mm (product width)

	65
	mm	833 mm
	min 210 mm
	max 235 mm
0	(depending on feet adjustment)

+ 25

Fig. 10a Fitting the anti-tilt bracket

Pivoting panel

Fig. 10b Opening the pivoting panel

Anti-tilt bracket

1 attached on the rear wall

4Move the cooker to the wall and adjust the height of the anti-tilt bracket so that it can engage in the slot on the cooker’s back, as shown in Fig.10a.

Lock pin

Cooker’s back

5Tighten the screws attaching the anti-tilt bracket.

6Push the cooker against the wall so that the anti-tilt bracket is fully inserted in the slot on the cooker’s back.

7New Zealand and Australia only: access the

bracket and fit the lock pin;

Open the pivoting panel (Fig. 10b).

Fit the lock pin through the bracket, as shown (Fig.10c).

Close the pivoting panel.

Slot on the cooker’s back

2

Lock pin correctly fitted

Fig. 10c New Zealand and Australia only: fitting the lock pin through the bracket