Fisher & Paykel OR90SDBSI installation instructions Storage compartment, Replacing the oven lamp

Page 37

Storage compartment

The storage compartment is accessible through the pivoting panel (Fig.31).

Important!

Do not store flammable material in the oven or in the storage compartment.

Care and cleaning 35

Pivoting panel

Fig. 31 Storage compartment

Replacing the oven lamp

1Turn the power to the cooker off at the wall.

2Let the oven cavity and the heating elements cool down.

3 Twist the lamp cover off.

4 Remove and replace the halogen lamp with a new one suitable for high temperatures (300oC) with the following specifications: 220-240V, E14 and same wattage as the lamp being replaced (check wattage stamped on the lamp).

Important!

Never replace the bulb with bare hands; contamination from your fingers can cause premature failure. Always use a clean cloth or gloves.

5Twist the lamp cover back on

6 Set the clock.

Note: oven bulb replacement is not covered by your warranty.

Left lamp	Left halogen
cover	lamp

Right halogen	Right lamp
lamp	cover

Fig.32 Replacing the oven lamp

Image 37

Contents

Installation instructions Page Contents Installation Safety and warningsGeneral Electrical Keep children away OperationImportant safety instructions Dimensions and clearances Installation instructionsCooker overall dimensions mm Levelling the cooker Fitting the adjustable feetFixing the backguard Moving the cookerTo fit the anti-tilt bracket Fitting the anti-tilt bracketVoltage and power consumption Connecting the power supply cableFeeder cable section Wiring diagram Wiring diagram key Before using your new oven, please Using your oven for the first timeIlluminated symbols Setting the clockButtons To set the clockFunction and temperature dials Using your ovenBake Cooking functionsBaking chart Lock stud Using the rotisserieRotate the fork screws to Loosen and tighten Fork Skewer Rotisserie drive holeUsing the electronic timer To set the oven for automatic cooking Automatic cookingInduction cooktop introduction Cooking zones display Been returned to 0 Off Choosing the right cookwareInduction cooking zone Choosing the right cookwarePower level Using your induction cooktopHot Surface Indicator Control dialsUsing the PowerBoost feature Using the Auto Heat-reduce featureMaximum usable power for the cooking zones Using your cooktop’s special featuresThermal protection Cooking guidelines Heat settingsGeneral advice Care and cleaningCleaning the outside of the cooker Cleaning the stainless steel surround strip Cleaning melts and spillovers Caring for your cooktop Metallic stainsDrop-down grill element Cleaning the inside of your ovenCleaning the fat filter Cleaning the enamel cavityCleaning the grill tray and shelves Fitting the sliding shelf supports Fitting and removing the sliding shelf supportsStorage compartment Turn the power to the cooker off at the wallReplacing the oven lamp Care and cleaning Removing the oven door Remove the inner glass retainer Removing the inner pane of glassRemoving the inner glass pane Remove the inner glass paneWhen replacing the inner glass pane, make sure that After cleaning, replace the inner glass paneReplace the glass retainer Replace the glass retainerRefit the door Error codes on the cooking zones display Cooktop fault codesError code Example As perTroubleshooting chart TroubleshootingBefore you call for service or assistance Warranty and serviceDealer Suburb Town Product detailsPage Page Page NZ AU GB IE