Fisher & Paykel OR90SDBSI Setting the clock, Buttons, Illuminated symbols, To set the clock

Page 17

Setting the clock

Buttons

15

sets the timer

sets the cooking time for automatic cooking

sets the stop time for automatic cooking

sets the clock, returns oven to manual mode, cancels automatic cooking

decreases time and beep volume

increases timeFig. 16 Clock display and control buttons

Illuminated symbols

	If the display shows		It means that...	Fore more information
		flashing with	The clock needs to be set.	See instructions below.
	A	0•00	The clock needs to be set.	See instructions below.
	A	0•00
	U	steadily lit	The oven is set for automatic
	T		cooking.
	T		Automatic cooking has finished	See section ‘Automatic cooking’
			Automatic cooking has finished	See section ‘Automatic cooking’

Oflashing and or has been set incorrectly (the

	beeping	stop time is before the time of
		day)
	steadily lit	The timer is set
			See section ‘Using the electronic timer’
	flashing and		See section ‘Using the electronic timer’
	flashing and	The time is up
	beeping	The time is up
	beeping

To set the clock

When the power to the appliance is turned on or restored after a power failure, 0•00 and AUTO will flash in the display.

1Press .

2Press and until you have the correct time of the day.

Image 17

Contents

Installation instructions Page Contents General Safety and warningsInstallation Electrical Keep children away OperationImportant safety instructions Cooker overall dimensions mm Installation instructionsDimensions and clearances Levelling the cooker Fitting the adjustable feetFixing the backguard Moving the cookerTo fit the anti-tilt bracket Fitting the anti-tilt bracketVoltage and power consumption Connecting the power supply cable Feeder cable section Wiring diagram Wiring diagram key Before using your new oven, please Using your oven for the first timeIlluminated symbols Setting the clockButtons To set the clockFunction and temperature dials Using your ovenBake Cooking functionsBaking chart Lock stud Using the rotisserieRotate the fork screws to Loosen and tighten Fork Skewer Rotisserie drive holeUsing the electronic timer To set the oven for automatic cooking Automatic cookingInduction cooktop introduction Cooking zones display Been returned to 0 Off Choosing the right cookwareInduction cooking zone Choosing the right cookwarePower level Using your induction cooktopHot Surface Indicator Control dialsUsing the PowerBoost feature Using the Auto Heat-reduce featureThermal protection Using your cooktop’s special featuresMaximum usable power for the cooking zones Cooking guidelines Heat settingsCleaning the outside of the cooker Care and cleaningGeneral advice Cleaning the stainless steel surround strip Cleaning melts and spilloversCaring for your cooktop Metallic stainsDrop-down grill element Cleaning the inside of your ovenCleaning the grill tray and shelves Cleaning the enamel cavityCleaning the fat filter Fitting the sliding shelf supports Fitting and removing the sliding shelf supportsReplacing the oven lamp Turn the power to the cooker off at the wallStorage compartment Care and cleaning Removing the oven door Remove the inner glass retainer Removing the inner pane of glassRemoving the inner glass pane Remove the inner glass paneWhen replacing the inner glass pane, make sure that After cleaning, replace the inner glass paneReplace the glass retainer Replace the glass retainerRefit the door Error codes on the cooking zones display Cooktop fault codesError code Example As perTroubleshooting chart TroubleshootingBefore you call for service or assistance Warranty and serviceDealer Suburb Town Product detailsPage Page Page NZ AU GB IE