Installation instructions | 9 |
Fitting the anti-tilt bracket
(seven-function models)
Important!
To restrain the appliance and prevent it tipping accidentally, fit a bracket to its rear to fix it securely to the wall. Make sure you also fit the supplied lock pin to the
To fit the
0
1 After you have located where the cooker +15 is to be positioned, mark on the wall the place where the two screws of the
2Drill two 8 mm diameter holes in the wall and insert the plastic plugs supplied.
Dotted line showing the position
of the cooker when installed
= =
75
min 95 - max 110
(depending on feet height adjustment)
Fig. 6a Fitting the anti-tilt bracket
FOURGAS COOKTOPFUNCTIONMODELS
Important!
Before drilling the holes, check that you will not damage any pipes or electrical wires.
3Loosely attach the
4Move the cooker to the wall and adjust the height of the
5Tighten the screws attaching the
6Push the cooker against the wall so that the
7Access the bracket and fit the lock pin;
Remove the drawer (Fig. 6b).
Fit the lock pin through the bracket, as shown (Fig.6c).
Refit the drawer.
1 | 2 | |
attached on the | ||
| rear wall |
|
| Cooker’s |
|
| back | Lock pin |
Lock pin |
| |
|
| correctly fitted |
1
2
3
4
Fig. 6b Removing the drawer
Slot on the
cooker’s back | Fig. 6c Fitting the lock pin through the bracket |
|
|
|
|