Fisher & Paykel DD90SDFTM2, DD90SDF(H)TX2 manual 7a Cavity Preparation, Water Connection

Page 10

7a CAVITY PREPARATION

10 mm

BENCHTOP

2 mm

Moisture protection tape must be applied.

Important!

The power outlet must be located in a cabinet adjacent to the dishwasher cavity.

220-240 VAC min. 7 A

10

Water Connection

Recommended COLD (Maximum 60°C).

These marks indicate formed bracket screw locations, if securing by drawer removal.

Important!

Adjacent cabinetry must not extend above cavity base

Services can be located either side of the dishwasher.

min. ø 60 mm

¾ “ BSP (GB20) to suit flat washer.

Water Pressure

Water softener models

Max. 1 MPa (145 psi)

Min. 0.1 MPa (14.5 psi)

Models without water softener

Max. 1 MPa (145 psi)

Min. 0.03 MPa (4.3 psi)

min. 200 mm

Image 10

Contents Installation Instructions Follow the Installation Sequence Relevant to Your Model DD90SDFHTX2 DD90SDFTM22a Safety and Warnings ALL Models 2b Additional Safety and Warnings Integrated Models only3a Parts Supplied ALL Models Optional3b Additional Parts Supplied with Integrated Models Attached to productProduct Dimensions PlanCabinetry Dimensions Cabinetry dimensions mmFront Panel Specifications Min mm ventilation gap 7a Cavity Preparation Water ConnectionShelf cutouts Maximum Distance of Hoses & Cord from Chassis Edge Left hand sidePage NOW Choose Which Installation Method a or b 9a Attach Side Mounting Brackets11a Pull Through Hoses & Move Into the Cavity 12a Secure the Drawer9b Integrated Models with Remote NZ AU only 10b Pull Through Hoses & Move Into the Cavity11b Remove the Drawer 12b Secure the Drawer to the Cabinetry 13b Refit the Drawer Onto the RunnersX14 17a Earth the Panel 18a Attach Panel to Product Badge zone When refitting Adjust Panel Height to Align the Cabinetry Gaps Connect Inlet Hose to Cold Water 24 Plug Product To required heightFinal Checklist Troubleshooting